Hostname: page-component-7479d7b7d-68ccn Total loading time: 0 Render date: 2024-07-11T06:22:50.507Z Has data issue: false hasContentIssue false

Effect of Zn and Mg doping on CuInS thin films and solar cells

Published online by Cambridge University Press:  01 February 2011

Tobias Enzenhofer
Affiliation:
Hahn-Meitner-Institut, Glienicker Strasse 100, 14109-Berlin, Germany
Thomas Unold
Affiliation:
Hahn-Meitner-Institut, Glienicker Strasse 100, 14109-Berlin, Germany
Roland Scheer
Affiliation:
Hahn-Meitner-Institut, Glienicker Strasse 100, 14109-Berlin, Germany
Hans-Werner Schock
Affiliation:
Hahn-Meitner-Institut, Glienicker Strasse 100, 14109-Berlin, Germany
Get access

Abstract

Solar cells based on CuInS2 still suffer from Voc limitation compared to the value expected from the bandgap. The open circuit voltage can be enhanced via controlled doping of small amounts of Zinc or Magnesium (< 1 at. %), however the underlying physical reason for this improvement is not understood so far. We have systematically studied the effect of diffusion of Zn and Mg into the absorber layers with photoluminescence and quantum efficiency measurements. ZnO (ZnMgO, MgF2) has been deposited onto the absorber layers and photoluminescence (PL) spectra at room temperature were recorded as a function of the annealing temperature. The modified emission spectra reveal a defect related transition with a strong luminescence signal. At the same time the open-circuit voltage of the Zn (Mg) doped CuInS2 cells are around 100 mV higher than the values found for the undoped cells from the same device process. We interpret these results as a reduced defect state density at the surface and an increased bulk defect concentration induced by the incorporation of Zn or Mg. Comparison of external quantum efficiency (EQE) and I/U measurements with the PL results support observed changes of the interface/bulk properties.

Type
Research Article
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Klaer, J., Luck, I., Boden, A., Klenk, R., Perez, I. G. and Scheer, R.. Thin Solid Films, 431-432, 534537 (2003)Google Scholar
2 Schock, H.W., Rau, U., Dullweber, T., Hanna, G., Balboul, M., T. Margorian-Friedlmeier, Jasenek, A., Kötschau, I., Kerber, H. und Wiesner, H.. Proceedings of the 16th EC PVSEC, Glasgow, Scottland, (2000)Google Scholar
3 Braunger, D., Dürr, Th., Hariskos, D., Köble, Ch., Walter, Th., Wieser, N. and Schock, H. W.. Proceedings of the 24th IEEE Photovoltaic Specialists Conference, IEEE, New York, (1988)Google Scholar
4 Luck, I., Henrion, W., Scheer, R., Doering, Th., Bente, K. and Lewerenz, H.J.. Cryst. Res. Technol., 31, 841844 (1996)Google Scholar
5 Töpper, K., Bruns, J., Scheer, R., Weber, M., Weidinger, A. and Bräunig, D.. Appl. Phys. Lett., 71, 482 (1997)Google Scholar
6 Binsma, J.J.M. and Giling, L.J.. J. Bloem. J. Lumin., 27, 55 (1982)Google Scholar
7 Binsma, J.J.M. and Giling, L.J.. J. Bloem. J. Lumin., 27, 35 (1982)Google Scholar
8 Maeda, K.. J. Phys. Chem. Solids, 26, 595 (1965)Google Scholar
9 Ueng, H.Y. and Hwang, H.L.. J. Phys. Chem. Solids, 50 (12), 1297 (1989)Google Scholar
10 Pankove, J. I.. Optical Processes in Semiconductors, Dover Publications, New York, (1975)Google Scholar
11 Yu, P. W.. J. Appl. Phys. 48, 50435051 (1977)Google Scholar
12 Shklovskij, B. I. und Efros, A. L.. Electronic Properties of Doped Semiconductors, Springer-Verlag, Berlin (1984)Google Scholar
13 Schmidt, T., Lischka, K. and Zulehner, W.. Phys. Rev. B, 45 (16), 8989 (1992)Google Scholar
14 Cooper, D.E., Bajaj, J. and Newman, P. R.. J. Cryst. Growth, 86, 544 (1988)Google Scholar