Hostname: page-component-7479d7b7d-pfhbr Total loading time: 0 Render date: 2024-07-12T01:36:13.187Z Has data issue: false hasContentIssue false
  • English
  • Français

Deposition of Tungsten Silicide Barrier Layers and Tungsten in Rectangular Vias

Published online by Cambridge University Press:  25 February 2011

Timothy S. Cale ,
Gregory B. Raupp  and
Manoj K. Jain
Timothy S. Cale
Affiliation:
Department of Chemical, Bio & Materials Engineering and Center for Solid State Electronics Research, Arizona State University, Tempe, AZ 85287-6006
Gregory B. Raupp
Affiliation:
Department of Chemical, Bio & Materials Engineering and Center for Solid State Electronics Research, Arizona State University, Tempe, AZ 85287-6006
Manoj K. Jain
Affiliation:
Department of Chemical, Bio & Materials Engineering and Center for Solid State Electronics Research, Arizona State University, Tempe, AZ 85287-6006
Get access

Abstract

Diffusion-reaction analysis of a two step process in which a tungsten silicide barrier layer is deposited in a rectangular trench by low pressure dichlorosilane reduction of tungsten hexafluoride followed by a complete tungsten fill by low pressure hydrogen reduction of tungsten hexafluoride reveals that high step coverage and high deposition rate can be readily achieved with logical selection of process parameters. This fact, coupled with the potential for accomplishing these deposition steps in the same single wafer reactor, suggests that this two step process may offer a high throughput alternative to blanket tungsten deposition by silane reduction.

Type
Articles
Information
MRS Online Proceedings Library (OPL) , Volume 181: Symposium B – Advanced Metallizations in Microelectronics , 1990 , 517
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Stimmell, J. B., in Tungsten and Other Refractory Metals for VLSI Applications IV, McConica, C. M. and Blewer, R. A., eds., MRS, Pittsburgh, PA, 1989, p. 1.Google Scholar
2. Schmitz, J. E. J., van der Sluis, W. L. N. and Montree, A. H., in Tungsten and Other Advanced Metals for VLSI/ULSI Applications V, Wong, S. S. and Furukawa, S., eds., MRS, Pittsburgh, PA, 1990, p. 117.Google Scholar
3. Joshi, R. V., Mehter, E., Chow, M., Ishaq, M., Kang, S., Geraghty, P. and Mclnerney, J., in Tungsten and Other Advanced Metals for VLSI/ULSI Applications Wong, V. S. S. and Furukawa, S., eds., MRS, Pittsburgh, PA, 1990, p. 157.Google Scholar
4. McConica, CM. and Churchill, S., in Tungsten and Other Refractory Metals for VLSI Applications III. Wells, V. A., ed., MRS, Pittsburgh, PA, 1988, p. 257.Google Scholar
5. Raupp, G. B. and Cale, T. S., Chemistry of Materials 1, 207 (1989).CrossRefGoogle Scholar
6. Shemansky, F. A., Jain, M. K., Cale, T. S. and Raupp, G. B., MRS Symp. Ser. 146. Hodul, D., Gelpey, J. C., Green, M. L., and Seidel, T. E., eds., MRS, Pittsburgh, PA, 1989, p. 173.Google Scholar
7. Chatterjee, S. and McConica, C. M., J. Electrochem. Soc. 137. 328 (1990).CrossRefGoogle Scholar
8. Raupp, G. B., Cale, T. S., Jain, M. K., Rogers, B., and Srinivas, D., presented at the 8th Intl. Conf. on Thin Films, San Diego, CA, April 1990, and submitted to Thin Solid Films.Google Scholar
9. Cale, T. S., Jain, M. K., and Raupp, G. B., presented at the 8th Intl. Conf. on Thin Films, San Diego, CA, April 1990, and submitted to Thin Solid Films.Google Scholar
10. McConica, C.M. and Krishnamani, K., J. Electrochem. Soc. 133. 2542 (1986).CrossRefGoogle Scholar