Hostname: page-component-7479d7b7d-t6hkb Total loading time: 0 Render date: 2024-07-10T19:37:49.585Z Has data issue: false hasContentIssue false

Nanocrystalline Superlattice Solar Cells

Published online by Cambridge University Press:  31 January 2011

Atul Madhavan
Affiliation:
atulm@iastate.edu, Iowa State University, Dept. of Electrical and Computer Engineering and Microelectronics Research Center, Ames, Iowa, United States
Nayan Chakravarty
Affiliation:
Nayan_Chakravarty@fakemail.com, Iowa State University, Dept. of Electrical and Computer Engineering and Microelectronics Research Center, Ames, Iowa, United States
Vikram L. Dalal
Affiliation:
vdalal@iastate.edu, Iowa State University, Dept. of Electrical and Computer Engineering and Microelectronics Research Center, Ames, Iowa, United States
Get access

Abstract

We report on the growth and properties of nanocrystalline Si superlattice solar cells. The solar cells consisted of a stack of alternating layers of amorphous and nanocrystalline Si. The thickness of each of the two layers in the superlattice structure was varied independently. It was found that when the nanocrystalline layer thickness was low, increasing the thickness of the amorphous layer in the superlattice systematically reduced the <220> grain size, while the <111> grain size remained essentially invariant. This fact shows that by interposing an amorphous layer between two nanocrystalline layers forces the nano grains to renucleate and regrow. It was also found that when the amorphous Si layer was too thick, there were significant problems with hole transport through the device. Measurements of defect densities and effective diffusion lengths showed that there was an optimum thickness of the amorphous layer (about 10 nm) for which the defect density was the lowest and the diffusion length was the highest. We also show that the absorption coefficient in nano Si depends upon the grain size and can be increased significantly by increasing the grain size.

Type
Research Article
Copyright
Copyright © Materials Research Society 2009

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Tawada, Y. Yamagishi, H. and Yamamoto, K. Solar Energy Materials and Solar Cells, 78, 647(2003)Google Scholar
2 Rech, B. Kluth, O. Repmann, T. Roschek, T. Springer, J. Müller, J., Finger, F. Stiebig, H. and Wagner, H. Solar Energy Materials and Solar Cells, 74, 439(2002)Google Scholar
3 Shah, A. V. Meier, J. Vallat-Sauvain, E., Wyrsch, N. Kroll, U. Droz, C. and Graf, U. Solar Energy Materials and Solar Cells, 78, 469(2003)Google Scholar
4 Dalal, Vikram L. U.S. Patent 4,253,882 “High efficiency thin-film multiple-gap photovoltaic device” (1981)Google Scholar
5 Repmann, T. Sehrbrock, B. Zahren, C. Siekmann, H. and Rech, B. Solar Energy Materials and Solar Cells, 90, 3047, (2006)Google Scholar
6 Biswas, R. Pan, B. C. Selvaraj, V., Proc. Of MRS, Vol. 862, 133(2005)Google Scholar
7 Ko ka, J., Fejfar, A. Stuchlíková, H., Stuchlík, J., Fojtík, P., Mates, T. Rezek, B. Luterová, K., vrek, V. and Pelant, I. Solar Energy Materials and Solar cells, 78, 493(2003)Google Scholar
8 Yan, B. J. Yue, G. Z. Yang, J and Guha, S., Appl. Phys. Lett. 85, 1955(2004)Google Scholar
9 Dalal, Vikram L. Graves, J. and Leib, J. Appl. Phys. Lett., 85, 1413(2004)Google Scholar
10 Madhavan, A. and Dalal, V. L. J. Non-Cryst. Solids, 354, 24032406 (2008)Google Scholar
11 Smit, C. Swaaij, C. Raccm van, Donker, H., Petit, Amhn, Kessels, Wmm, Sanden, Mcm van de, J. Appl. Phys. 94, 3582 (2003)Google Scholar
12 Dalal, Vikram and Sharma, Puneet, Appl. Phys. Lett. 86, 103510(2005)Google Scholar
13 Dalal, Vikram, Muthukrishnan, Kamal, Niu, Xuejun and Stieler, Daniel, J. Non-Cryst. Solids, 352, 892(2006),Google Scholar