Hostname: page-component-5c6d5d7d68-wp2c8 Total loading time: 0 Render date: 2024-08-06T13:26:12.888Z Has data issue: false hasContentIssue false
  • English
  • Français

Electrically flat/optically rough substrates for efficiencies above 10% in n-i-p thin-film silicon solar cells

Published online by Cambridge University Press:  10 May 2012

Karin Söderström ,
Grégory Bugnon ,
Franz-Josef Haug  and
Christophe Ballif
Karin Söderström
Affiliation:
Ecole Polytechnique Fédérale de Lausanne (EPFL), Institute of Microengineering (IMT), Photovoltaics and Thin-Film Electronics Laboratory (PV-Lab), 2000 Neuchâtel, Switzerland.
Grégory Bugnon
Affiliation:
Ecole Polytechnique Fédérale de Lausanne (EPFL), Institute of Microengineering (IMT), Photovoltaics and Thin-Film Electronics Laboratory (PV-Lab), 2000 Neuchâtel, Switzerland.
Franz-Josef Haug
Affiliation:
Ecole Polytechnique Fédérale de Lausanne (EPFL), Institute of Microengineering (IMT), Photovoltaics and Thin-Film Electronics Laboratory (PV-Lab), 2000 Neuchâtel, Switzerland.
Christophe Ballif
Affiliation:
Ecole Polytechnique Fédérale de Lausanne (EPFL), Institute of Microengineering (IMT), Photovoltaics and Thin-Film Electronics Laboratory (PV-Lab), 2000 Neuchâtel, Switzerland.
Get access

Abstract

Substrates with extremely low roughness to allow the growth of good-quality silicon material but that nevertheless present high light trapping properties are presented. In a first application, silver reflectors are used in single and tandem-junction amorphous silicon (a-Si:H) solar cells. High initial (stable) efficiencies of 10.4 % (8.1 %) for single-junction a-Si:H cells on glass and 11.1 % (9.2 %) for tandem-junction a-Si:H/a-Si:H cells on plastic are obtained. A second application better suited to multi-junction solar cells based on microcrystalline silicon (μc-Si:H) solar cells is presented: the substrate consists of rough zinc oxide (ZnO) grown on a flat silver reflector which is covered with a-Si:H; polishing of this structure yields an a-Si:H/ZnO interface that provides high light scattering even though the cell is deposited on a flat interface. We present results of ∼ 4-μm-thick μc-Si:H solar cells prepared on such substrates with high open-circuit voltages of 520 mV. A large relative efficiency gain of 20% is observed compared to a co-deposited cell grown directly on an optimized textured substrate.

Keywords

electrical propertiesoptical propertiesthin film
Type
Articles
Information
MRS Online Proceedings Library (OPL) , Volume 1426: Symposium A – Amorphous and Polycrystalline Thin-Film Silicon Science and Technology–2012 , 2012 , pp. 39 - 44
Copyright
Copyright © Materials Research Society 2012

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Deckman, H. W., Wronski, C. R., Witzke, H., and Yablonovitch, E., Appl. Phys. Lett. 42, 968–970 (1983).CrossRefGoogle Scholar
Yue, G., Sivec, L., Owens, J. M., Yan, B., Yang, J., and Guha, S., Appl. Phys. Lett. 95, 263501 (2009).CrossRefGoogle Scholar
Sai, H., Jia, H., and Kondo, M., J. Appl. Phys. 108, 044505 (2010).Google Scholar
Müller, J., Rech, B., Springer, J., and Vanecek, M., Sol. Energy 77, 917–930 (2004).CrossRefGoogle Scholar
Sakai, H., Yoshida, T., Hama, T., and Ichikawa, Y., Jpn. J. Appl. Phys. 29, 630–635 (1990).CrossRefGoogle Scholar
Nasuno, Y., Kondo, M., and Matsuda, A., Jpn. J. Appl. Phys. 40, L303–L305 (2001).CrossRefGoogle Scholar
Python, M., Vallat-Sauvain, E., Bailat, J., Dominé, D., Fesquet, L., Shah, A., and Ballif, C., J. Non-Cryst. Solids 354, 2258–2262 (2008).CrossRefGoogle Scholar
Li, H., Franken, R., Stolk, R.L., Rath, J.K., and Schropp, R.E.I., Sol. St. Phen. 131–133, 27–32 (2008).Google Scholar
Sai, H., Kanamori, Y., and Kondo, M., Appl. Phys. Lett. 98, 315502 (2011).CrossRefGoogle Scholar
Söderström, K., Bugnon, G., Haug, F.-J., Nicolay, S., and Ballif, C., available online in Sol. Energ. Mater. Sol. C: DOI: 10.1016/j.solmat.2012.02.003. (2012).Google Scholar
Söderström, T., Haug, F.-J., Terrazzoni-Daudrix, V., and Ballif, C., J. of Appl. Phys. 103, 114509 (2008).CrossRefGoogle Scholar
Biron, R., Pahud, C., Haug, F.-J., Escarré, J., Söderström, K., and Ballif, C., J. of Appl. Phys., 110, 124511 (2011).CrossRefGoogle Scholar
Söderström, K., Escarré, J., Cubero, O., Haug, F.-J., Perregaux, S., and Ballif, C., Prog. Photovoltaics 19, 202–210 (2011).CrossRefGoogle Scholar
Escarré, J., Söderström, K., Battaglia, C., Haug, F.-J., and Ballif, C., Sol. Energ. Mater. Sol. C. 95, 881–886 (2011).CrossRefGoogle Scholar
Cuony, P., Marending, M., Alexender, D.T. L., Boccard, M., Bugnon, G., Despeisse, M., and Ballif, C., Appl. Phys. Lett. 97, 213502 (2010).CrossRefGoogle Scholar