Hostname: page-component-84b7d79bbc-5lx2p Total loading time: 0 Render date: 2024-07-29T12:54:52.832Z Has data issue: false hasContentIssue false

A Comparison of the Mechanical Properties and the Impact of Contact Induced Damage in a- and c- Axis ZnO Single Crystals

Published online by Cambridge University Press:  01 February 2011

Victoria A. Coleman
Affiliation:
victoria.coleman@mkem.uu.se, Uppsala University, Physics/Materials Chemistry, Lägerhyddsvägen 1, Uppsala, 752 37, Sweden, +46184713768, +46184713768
J E Bradby
Affiliation:
jeb109@rsphysse.anu.edu.au, The Australian National University, Department of Electronic Materials Engineering, Research School of Physical Sciences and Engineering, Canberra, 0200, Australia
C Jagadish
Affiliation:
cxj109@rsphysse.anu.edu.au, The Australian National University, Department of Electronic Materials Engineering, Research School of Physical Sciences and Engineering, Canberra, 0200, Australia
M R Phillips
Affiliation:
matthew.phillips@uts.edu.au, University of Technology, Sydney, Microstructural Analysis Unit, Broadway, 2007, Australia
Get access

Abstract

Nanoindentation studies were conducted on a-axis oriented ZnO single crystals. The mechanical properties and deformation mechanisms were monitored and compared to previously determined data from c-axis material. Hardness and modulus values reveal that a-axis ZnO is significantly softer than c-axis material (measured hardness of 2 ± 0.2 GPa) and behaves much more plastically. Additionally, the influence of contact induced damage upon the defect structure of a-axis material was also examined using cathodoluminescence spectroscopy and monochromatic imaging to monitor the luminescence from indent sites. Deformation directly under the indent site enhanced the occurrence of red defect luminescence, and was attributed to a native defect in ZnO that has a higher formation energy than the defects responsible for the green and yellow visible defect bands, which were present in the ZnO during growth and were found to cluster to the indent site during annealing.

Type
Research Article
Copyright
Copyright © Materials Research Society 2007

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Kahn, M. Y., Brown, L. M. and Chaduri, M. M., J. Phys. D Appl. Phys. 25, A257 (1992).Google Scholar
2. Kucheyev, S. O., Bradby, J. E., Williams, J. S., Jagadish, C. and Swain, M. V., Appl. Phys. Lett. 80, 956 (2002).Google Scholar
3. Coleman, V. A., Bradby, J. E., Jagadish, C. and Phillips, M. R., Appl. Phys. Lett., 89, 082102 (2006).Google Scholar
4. Bradby, J. E., Kucheyev, S. O., Williams, J. S., Jagadish, C., Swain, M. V., Munroe, P. and Philips, M. R., Appl. Phys. Lett. 80, 4537 (2002).Google Scholar
5. Prasad, S. V. and Zabinski, J. S., Wear 203–204, 498 (1997).Google Scholar
6. Mayo, M. J., Siegel, R. W., Liao, Y. X. and Nix, W. D., J. Mat. Res. 7, 973 (1992).Google Scholar
7. Klopfstein, M. J., Lucca, D. A. and Cantwell, G., Phys. Stat. Sol.(a) 196(1),: R1 (2003).Google Scholar
8. Takkouk, Z., Brihi, N., Guergouri, K. and Marfaing, Y., Physica B 366, 185 (2005).Google Scholar
9. Klopfstein, M. J. and Lucca, D. A., Appl. Phys. Lett. 87, 131 906 (2005).Google Scholar
10. Czernuszka, J. T. and Pratt, N., Phil. Mag. Lett. 61(3), 83 (1990).Google Scholar
11. Field, J. S. and Swain, M. V., J. Mat.Res. 8, 297 (1993).Google Scholar