Hostname: page-component-76fb5796d-vfjqv Total loading time: 0 Render date: 2024-04-26T16:52:48.011Z Has data issue: false hasContentIssue false
  • English
  • Français

Integrated Fabrication Processes for Solid-Oxide Fuel Cells Using Thermal Plasma Spray Technology

Published online by Cambridge University Press:  31 January 2011

François Gitzhofer ,
Maher Boulos ,
Joachim Heberlein ,
Rudolf Henne ,
Takamasa Ishigaki  and
Toyonobu Yoshida
Get access

Extract

In the manufacture of solid-oxide fuel cells (SOFCs), thermal-plasma technology, especially plasma spraying, offers several advantages, the most important of which is the ability to achieve considerably higher deposition rates than those that can be obtained with such approaches as physical or chemical vapor deposition (PVD or CVD). This article describes an international collaborative research project partially funded by NEDO (New Energy and Industrial Technology Development Organization, Japan) and carried out at five research laboratories around the world: at the University of Tokyo and National Institute for Research in Inorganic Materials (NIRIM) in Japan, the University of Minnesota in the United States, the University of Sherbrooke in Canada, and DLR—Stuttgart in Germany. The objective of the project was to conduct a comparative study on the possible use of four thermal-plasma spraying techniques for the integrated fabrication of SOFCs.

Type
Research Article
Information
MRS Bulletin , Volume 25 , Issue 7: Thermal Spray Coatings , July 2000 , pp. 38 - 42
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1.Yoshida, T., Okada, T., Hamatani, H., and Kumaoka, H., Plasma Sources Sci. Technol. 1 (1992) p. 195.CrossRefGoogle Scholar
2.Coulombe, S., Boulos, M.I., and Sakuta, T., J. Meas. Sci. Technol. 6 (1995) p. 383.CrossRefGoogle Scholar
3.Mailhot, K., Gitzhofer, F., and Boulos, M.I., in Proc. 10th United Thermal Spray Conf. (UTSC'97) p. 21.Google Scholar
4.Chen, H.C. and Heberlein, J., in Proc. 13th Int. Symp. on Plasma Chemistry, edited by Wu, C.K. (IUPAC Subcommittee on Plasma Chemistry, Beijing, China, 1997) p. 320.Google Scholar
5.Chen, H.C., Heberlein, J., and Yoshida, T., in Proc. 15th Int. Thermal Spray Conf., edited by Coddet, C. (Nice, France, 1998) p. 1309.Google Scholar
6.Chen, H.C., Heberlein, J., and Henne, R., “Integrated Fabrication Process for Solid-Oxide Fuel Cells in a Triple-Torch Plasma Reactor,” J. Thermal Spray Technol. 9 (2000) accepted for publication.CrossRefGoogle Scholar