Hostname: page-component-77c89778f8-vsgnj Total loading time: 0 Render date: 2024-07-17T11:10:28.291Z Has data issue: false hasContentIssue false
  • English
  • Français

Determination of the Young's modulus of thermally sprayed coatings using a modellized cantilever test

Published online by Cambridge University Press:  24 March 2004

H. Liao ,
Z. Feng ,
G. Jandin  and
C. Coddet
Get access

Abstract

This paper describes a simple and efficient method to identify Young's modulus of thermally sprayed coatings. The mechanical method is based on the cantilever beam test, without the use of a strain gauge, combined with a finite element numerical modelling and optimization technique. The influence of coating roughness was taken into account in this work. Several types of coatings were tested and their Young's moduli were calculated. A sensibility analysis was also performed.

Type
Research Article
Information
Metallurgical Research & Technology , Volume 101 , Issue 2: Science et Génie des MatériauxContraintes résiduelles (suite) , February 2004 , pp. 109 - 114
Copyright
© La Revue de Métallurgie, 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)