The nature of the turbulent motion in a boundary layer with zero longitudinal pressure gradient has been investigated with the techniques of hot-wire anemometry which have been developed for the study of shear flow in wakes. Measurements have been made of the intensities of the turbulent velocity components, the turbulent shear stresses, the rates of transport of turbulent energy by diffusive movements, the intensities and flattening factors of the down-stream spatial derivatives of the three velocity components, and spectra of the down-stream component of the velocity fluctuation, at traverses through the boundary layer at three stations where the Reynolds numbers (based on the displacement thickness and free stream velocity) were respectively 3630, 4360 and 5080. Over the range of measurement, which did not include the laminar sublayer, the turbulent motion was similar at all three stations, and could be described in terms of universal functions. By considering the turbulent energy balance, it is shown that, except in the outer part of the layer where the turbulence resembles strongly the turbulence in a wake, there is a strong flow of energy directed toward the wall and transported by the action of turbulent pressure gradients. It is concluded that, most probably in contact with the laminar sublayer, there must be a ‘dissipative layer’ within which most of the turbulent energy dissipation takes place, and that the bulk of the eddies are, in a sense, attached to the wall and have very high rates of shear in that region. In agreement with this view of the structure of the turbulence, length scales derived from the apparent eddy viscosity and the local turbulent intensity are found to be comparable with distance from the wall. Length scales in the direction of the mean stream are much larger, and it is believed that the typical eddy is very elongated in this direction, and has its vorticity directed roughly parallel to the direction of maximum positive mean rate of strain.