Hostname: page-component-5c6d5d7d68-pkt8n Total loading time: 0 Render date: 2024-08-15T22:40:05.340Z Has data issue: false hasContentIssue false
  • English
  • Français

The Design of Reliable Digital Computers for Air Traffic Control

Published online by Cambridge University Press:  18 January 2010

J. C. Cluley
J. C. Cluley
Affiliation:
(University of Birmingham)
Get access Rights & Permissions [Opens in a new window]

Abstract

A number of air traffic control authorities are now introducing electronic digital computers into air traffic control systems in order to speed operations and reduce the burden on controllers. These machines will initially be used for the routine clerical and data storage operations, but their full capabilities can only be used if they are given a much greater share of the control task and allowed to make logical decisions and intervene in the handling of the traffic. In such cases the computer will be performing a task that cannot be handed over to a human operator at a moment's notice in the event of a machine failure, and extreme reliability becomes probably the most important single attribute of a computer used in such a system.

Although computers of adequate speed and capacity are being produced for commercial and scientific uses, with reliabilities sufficient for these purposes, the frequency of faults and the time required for routine maintenance are both far too large to permit their full-time use in an air traffic control system. The reliabilities of typical components and systems are discussed in the following section.

1. The reliability of typical components and systems. The reports of a number of computer users suggest that ‘availabilities’ of 97–99 percent are readily attained, so that only 1–3 percent of the available working time is lost due to unscheduled maintenance.

Type
Research Article
Information
The Journal of Navigation , Volume 15 , Issue 4 , October 1962 , pp. 387 - 396
Copyright
Copyright © The Royal Institute of Navigation 1962

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1Dummer, G. W. A. (1961). Recent advances in micro-miniaturization reliable components, and cooling techniques, Solid State Electronics, 2, No. 1, 18.CrossRefGoogle Scholar
2Brewer, R. and Richards, D. J. E. (1961). Life characteristics of some typical semi-conductor devices, J. Brit. I.R.E., Paper No. 640, 12, No. 6, 485.Google Scholar
3McMullen, V. J. and Cox, P. (1961). The reliability of an experimental transistorized data handling system, J. Brit. I.R.E., 22, No. 1, 17.Google Scholar
4 Ed. Shwop, J. E. and Sullivan, H. J. (1961). Semi-conductor reliability, Chapman and Hall.Google Scholar
5Creveling, C. J. (1956). Increasing the reliability of electronic equipment by the use of redundant circuits, Proc. I.E.E., 44, 509.Google Scholar
6Suran, J. J. (1961). The use of passive redundancy in electronic systems, I.R.E. Trans. MIL-5, No. 3.Google Scholar
7Moore, E. F. and Shannon, C. E. (1956). Reliable circuits using less reliable relays, J. Franklin Inst., 262, 191 and 281.CrossRefGoogle Scholar
8Kochen, M. (1959). Extension of Moore-Shannon model for relay circuits, I.B.M. Journal Res. Dev., 3, 169.Google Scholar
9Ratcliffe, S. (1960). Reliability of air traffic control computers, RRE Memo., No. 1717 (Unpublished).Google Scholar
10Brown, W. G., Tierney, J., and Wasserman, R. (1961). Improvement of electronic-computer reliability through the use of redundancy, I.R.E. Trans. EC-10, No. 3.Google Scholar