Article contents
Optimization of an External Gear Pump using Response Surface Method
Published online by Cambridge University Press: 30 April 2020
Abstract
Design of a new gear pump requires many considerations to get good pump efficiency. In order to achieve optimal results, all parameters must be optimized from the design stage. In this study, ANSYS CFX was used to make parametric analysis in order to optimize a new design of gear pump. Two parameters which are inlet diameter and rotation speed are considered. The response surface method gives an optimum design point for inlet diameter of 15mm and rotation speed of 3500 rev/min. Twin vortices are created in the inlet and the outlet of pump, which strangle the flow. In order to reduce their negative effects on the flow, fillets are created at the inlet and the outlet of the pump.
- Type
- Research Article
- Information
- Copyright
- Copyright © 2020 The Society of Theoretical and Applied Mechanics
References
REFERENCES
- 8
- Cited by