Hostname: page-component-788cddb947-t9bwh Total loading time: 0 Render date: 2024-10-13T22:04:47.719Z Has data issue: false hasContentIssue false
  • English
  • Français

Transmission electron microscopy and electron energy loss spectroscopy analysis of ultrathin amorphous carbon films

Published online by Cambridge University Press:  03 March 2011

D. Wan  and
K. Komvopoulos
D. Wan
Affiliation:
Department of Mechanical Engineering, University of California, Berkeley, California 94720
K. Komvopoulos
Affiliation:
Department of Mechanical Engineering, University of California, Berkeley, California 94720
Get access

Abstract

Transmission electron microscopy (TEM) and analytic TEM were used to study the microstructure of amorphous carbon (a-C) films of thickness in the range of 5–100 nm deposited on Si(100) by radio-frequency (rf) sputtering. High-resolution cross-section TEM revealed a two-layer structure consisting of the a-C film and an ultrathin interface layer, in agreement with electron energy loss spectroscopy results. The presence of a 35-Å-thick interface layer (regardless of the deposition conditions) indicates that nucleation and initial growth of the a-C films were mainly controlled by the substrate surface condition. Mass-thickness contrast in bright-field TEM images showed an interface layer denser than the a-C film. This layer, believed to consist of Si, a-C, and SiC, enhances the adhesion of the film to the silicon substrate and accommodates the residual stress in the film. High-resolution cross-section TEM images revealed the presence of platelike nanocrystallites (∼35 Å in size) randomly distributed in the a-C film and oriented parallel to the surface. The possible mechanisms leading to the formation of these nanocrystalline structures are discussed in terms of sputtering phenomena occurring during film deposition.

Keywords

MicrostructureThin filmAmorphous
Type
Articles
Information
Journal of Materials Research , Volume 19 , Issue 7 , July 2004 , pp. 2131 - 2136
Copyright
Copyright © Materials Research Society 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Aisenberg, S. and Chabot, R.: Ion-beam deposition of thin films of diamondlike carbon. J. Appl. Phys. 42, 2953 (1971).CrossRefGoogle Scholar
2.Ishikawa, J., Takeiri, Y., Ogawa, K. and Takagi, T.: Transparent carbon film prepared by mass-separated negative-carbon-ion-beam deposition. J. Appl. Phys. 61, 2509 (1987).CrossRefGoogle Scholar
3.Kovarik, P., Bourdon, E.B.D. and Prince, R.H.: Electron-energy-loss characterization of laser-deposited a -C, a -C:H, and diamond films. Phys. Rev. B 48, 12123 (1993).Google ScholarPubMed
4.Jungnickel, G., Kuhn, M., Deutschmann, S., Richter, F., Stephan, U., Blaudeck, P. and Frauenheim, T.: Structure and chemical bonding in high-density amorphous-carbon. Diamond Relat. Mater. 3, 1056 (1994).CrossRefGoogle Scholar
5.Bubenzer, A., Dischler, B., Brandt, G. and Koidl, P.: rf-plasma deposited amorphous hydrogenated hard carbon thin films: Preparation, properties, and applications. J. Appl. Phys. 54, 4590 (1983).CrossRefGoogle Scholar
6.Savvides, N.: Deposition parameters and film properties of hydrogenated amorphous silicon prepared by high rate dc planar magnetron reactive sputtering. J. Appl. Phys. 55, 4232 (1984).CrossRefGoogle Scholar
7.Cho, N-H., Krishnan, K.M., Veirs, D.K., Rubin, M.D., Hopper, C.B., Bhushan, B. and Bogy, D.B.: Chemical structure and physical properties of diamond-like amorphous carbon films prepared by magnetron sputtering. J. Mater. Res. 5, 2543 (1990).CrossRefGoogle Scholar
8.Logothetidis, S.: Hydrogen-free amorphous carbon films approaching diamond prepared by magnetron sputtering. Appl. Phys. Lett. 69, 158 (1996).CrossRefGoogle Scholar
9.Lu, W. and Komvopoulos, K.: Dependence of growth and nanomechanical properties of ultrathin amorphous carbon films on radio frequency sputtering conditions. J. Appl. Phys. 86, 2268 (1999).CrossRefGoogle Scholar
10.Lifshitz, Y.: Hydrogen-free amorphous carbon films: Correlation between growth conditions and properties. Diamond Relat. Mater. 5, 388 (1996).CrossRefGoogle Scholar
11.Lifshitz, Y.: Diamond-like carbon—present status. Diamond Relat. Mater. 8, 1659 (1999).CrossRefGoogle Scholar
12.Robertson, J.: Diamond-like amorphous carbon. Mater. Sci. Eng. R 37, 129 (2002).CrossRefGoogle Scholar
13.Lioutas, C.B., Vouroutzis, N., Logothetidis, S. and Lefakis, H.: Transmission electron microscopy investigation of the structural characteristics of amorphous tetrahedral carbon films. Thin Solid Films 319, 144 (1998).CrossRefGoogle Scholar
14.Komninou, P., Nouet, G., Patsalas, P., Kehagias, T., Gioti, M., Logothetidis, S. and Karakostas, T.: Crystalline structures of carbon complexes in amorphous carbon films. Diamond Relat. Mater. 9, 703 (2000).CrossRefGoogle Scholar
15.Davis, C.A., Knowles, K.M. and Amaratunga, G.A.J.: Cross-sectional structure of tetrahedral amorphous carbon thin films. Surf. Coat. Technol. 76, 316 (1995).CrossRefGoogle Scholar
16.Ramírez, A.G., Itoh, T. and Sinclair, R.: Crystallization of amorphous carbon thin films in the presence of magnetic media. J. Appl. Phys. 85, 1508 (1999).CrossRefGoogle Scholar
17.Berger, S.D., McKenzie, D.R. and Martin, P.J.: EELS analysis of vacuum arc-deposited diamond-like films. Philos. Mag. Lett. 57, 285 (1988).CrossRefGoogle Scholar
18.Bruley, J., Williams, D.B., Cuomo, J.J. and Pappas, D.P.Quantitative near-edge structure analysis of diamond-like carbon in the electron microscope using a two-window method. J. Microsc. 180, 22 (1995).CrossRefGoogle Scholar
19.Fallon, P.J., Veerasamy, V.S., Davis, C.A., Robertson, J., Amaratunga, G.A.J., Milne, W.I. and Koskinen, J.: Properties of filtered-ion-beam-deposited diamondlike carbon as a function of ion energy. Phys. Rev. B 48, 4777 (1993).CrossRefGoogle ScholarPubMed
20.Davis, C.A., Amaratunga, G.A.J. and Knowles, K.M.: Growth mechanism and cross-sectional structure of tetrahedral amorphous carbon thin films. Phys. Rev. Lett. 80, 3280 (1998).CrossRefGoogle Scholar
21.Williams, D.B., Carter, C.B.: Transmission Electron Microscopy I: Basics (Plenum, New York, 1996).CrossRefGoogle Scholar
22.Williams, D.B., Carter, C.B.: Transmission Electron Microscopy Imaging III: (Plenum, New York, 1996).CrossRefGoogle Scholar
23.Yuan, J., Saeed, A., Brown, L.M. and Gaskell, P.H.: The structure of highly tetrahedral amorphous diamond-like carbon. III. Study of inhomogeneity by high-resolution inelastic scanning transmission electron microscopy. Philos. Mag. B 66, 187 (1992).CrossRefGoogle Scholar
24.Williams, D.B., Carter, C.B.: Transmission Electron Microscopy IV: Spectrometry (Plenum, New York, 1996).CrossRefGoogle Scholar
25.Logothetidis, S., Gioti, M. and Patsalas, P.: Real-time monitoring, growth kinetics and properties of carbon based materials deposited by sputtering. Diamond Relat. Mater. 10, 117 (2001).CrossRefGoogle Scholar
26.Kelires, P.C., Gioti, M. and Logothetidis, S.: Interfacial stability and atomistic processes in the a -C/Si(100) heterostructure system. Phys. Rev. B 59, 5074 (1999).Google Scholar
27.Somorjai, G.A., Principles of Surface Chemistry (Prentice-Hall, Englewood Cliffs, NJ, 1972), p. 102.Google Scholar
28.Ohring, M., The Materials Science of Thin Films (Academic, Boston, MA, 1992), Chap. 2.Google Scholar