Hostname: page-component-78c5997874-xbtfd Total loading time: 0 Render date: 2024-11-01T20:01:56.816Z Has data issue: false hasContentIssue false
  • English
  • Français

Three-dimensional anodes prepared by electrodeposition of β-PbO2 onto reticulated vitreous carbon with different porosities

Published online by Cambridge University Press:  03 October 2016

Rosimeire M. Farinos  and
Luís A.M. Ruotolo
Rosimeire M. Farinos
Affiliation:
Department of Chemical Engineering, Federal University of São Carlos, Sao Carlos 13565-905, Brazil
Luís A.M. Ruotolo*
Affiliation:
Department of Chemical Engineering, Federal University of São Carlos, Sao Carlos 13565-905, Brazil
*
a) Address all correspondence to this author. e-mail: pluis@ufscar.br
Get access

Abstract

The aim of this study was to obtain a tridimensional electrode with an even greater specific surface area (a s), using the electrodeposition of PbO2 films onto 45, 60, and 80 ppi RVC substrates applying different current densities. The kinetics and efficiency of decolorization of Reactive Blue 19 (RB19) dye achieved with the 60 ppi RVC/PbO2 were higher than obtained with a flat PbO2 electrode and 45 ppi RVC/PbO2, due not only to a greater electrochemically active area, but also especially due to the substantial increase in mass transfer caused by the turbulence generated by the porous matrix. It was found that the coating and the formation of β-PbO2 was only possible on the 60 ppi substrate applying 3.5 mA/cm2; in the case of the 80 ppi substrate, the uneven distribution of potential and current within the porous electrode did not allow establishment of suitable operational conditions that permitted complete and uniform coating of the substrate.

Keywords

catalyticcoatingelectrodeposition
Type
Articles
Information
Journal of Materials Research , Volume 31 , Issue 20 , 28 October 2016 , pp. 3168 - 3178
Check for updates
Copyright
Copyright © Materials Research Society 2016 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

World Health Organization: Health Risks of Persistent Organic Pollutants from Long-range Transboundary Air Pollution (WHO, Amersfoort, 2003).Google Scholar
Appenzeller, B.M.R. and Tsatsakis, A.M.: Hair analysis for biomonitoring of environmental and occupational exposure to organic pollutants. Toxicol. Lett. 210, 119 (2012).CrossRefGoogle ScholarPubMed
Maldonado, M.I., Passarinho, P.C., Oller, I., Gernjak, W., Fernandez, P., Blanco, J., and Malato, S.: Photocatalytic degradation of EU priority substances: A comparison between TiO2 and Fenton plus photo-Fenton in a solar pilot plant. J. Photochem. Photobiol., A 185, 354 (2007).Google Scholar
Wojnárovits, L. and Takács, E.: Rate coefficients of hydroxyl radical reactions with pesticide molecules and related compounds: A review. Radiat. Phys. Chem. 96, 120 (2014).Google Scholar
Kapałka, A., Fóti, G., and Comninellis, C.: Kinetic modelling of the electrochemical mineralization of organic pollutants for wastewater treatment. J. Appl. Electrochem. 38, 7 (2007).CrossRefGoogle Scholar
Panizza, M. and Cerisola, G.: Direct and mediated anodic oxidation of organic pollutants. Chem. Rev. 109, 6541 (2009).Google Scholar
Iniesta, J., Michaud, P.A., Panizza, M., Cerisola, G., Aldaz, A., and Comninellis, C.: Electrochemical oxidation of phenol at boron-doped diamond electrode. Electrochim. Acta 46, 3573 (2001).CrossRefGoogle Scholar
Scialdone, O., Galia, A., Guarisco, C., Randazzo, S., and Filardo, G.: Electrochemical incineration of oxalic acid at boron doped diamond anodes: Role of operative parameters. Electrochim. Acta 53, 2095 (2008).Google Scholar
Aquino, J.M., Rodrigo, M.A., Rocha-Filho, R.C., Sáez, C., and Cañizares, P.: Influence of the supporting electrolyte on the electrolyses of dyes with conductive-diamond anodes. Chem. Eng. J. 184, 221 (2012).CrossRefGoogle Scholar
Montilla, F., Morallo, E., De Battisti, A., Benedetti, A., Yamashita, H., and Vázques, J.L.: Preparation and characterization of antimony-doped tin dioxide electrodes. Part 2. XRD and EXAFS characterization. J. Phys. Chem. B 108, 5044 (2004).Google Scholar
Li, X., Pletcher, D., and Walsh, F.C.: Electrodeposited lead dioxide coatings. Chem. Soc. Rev. 40, 3879 (2011).Google Scholar
Costa, F.R. and Da Silva, L.M.: Fabrication and characterization of a porous gas-evolving anode constituted of lead dioxide microfibers electroformed on a carbon cloth substrate. Electrochim. Acta 70, 365 (2012).Google Scholar
Jüttner, K., Galla, U., and Schmieder, H.: Electrochemical approaches to environmental problems in the process industry. Electrochim. Acta 45, 2575 (2000).CrossRefGoogle Scholar
Sirés, I., Brillas, E., Oturan, M., Rodrigo, M.A., and Panizza, M.: Electrochemical advanced oxidation processes: Today and tomorrow. Environ. Sci. Pollut. Res. 21, 8336 (2014).Google Scholar
Rajkumar, D., Guk Kim, J., and Palanivelu, K.: Indirect electrochemical oxidation of phenol in the presence of chloride for wastewater treatment. Chem. Eng. Technol. 28, 98 (2005).Google Scholar
Polcaro, A.M., Vacca, A., Mascia, M., Palmas, S., Pompei, R., and Laconi, S.: Characterization of a stirred tank electrochemical cell for water disinfection processes. Electrochim. Acta 52, 2595 (2007).Google Scholar
Santos, J.L.C., Geraldes, V., Velizarov, S., and Crespo, J.G.: Characterization of fluid dynamics and mass-transfer in an electrochemical oxidation cell by experimental and CFD studies. Chem. Eng. J. 157, 379 (2010).Google Scholar
Aquino, J.M., Rocha-Filho, R.C., Ruotolo, L.A.M., Bocchi, N., and Biaggio, S.R.: Electrochemical degradation of a real textile wastewater using β-PbO2 and DSA® anodes. Chem. Eng. J. 251, 138 (2014).Google Scholar
Pletcher, D., Whyte, I., Walsh, F.C., and Millington, J.P.: Reticulated vitreous carbon cathodes for metal ion removal from process streams Part II: Removal of copper (II) from acid sulphate media. J. Appl. Electrochem. 21, 667 (1991).Google Scholar
Britto-Costa, P.H. and Ruotolo, L.A.M.: Mass transfer study on the electrochemical removal of copper ions from synthetic effluents using reticulated vitreous carbon. Environ. Technol. 34, 437 (2013).Google Scholar
Recio, F.J., Herrasti, P., Sirés, I., Kulak, A.N., Bavykin, D.V., Ponce-de-León, C., and Walsh, F.C.: The preparation of PbO2 coatings on reticulated vitreous carbon for the electro-oxidation of organic pollutants. Electrochim. Acta 56, 5158 (2011).Google Scholar
Wang, J.: Deposition of metals at a flow-through reticulated vitreous carbon electrode coupled with on-line monitoring of the effluent. J. Electrochem. Soc. 130, 1814 (1983).Google Scholar
Friedrich, J.M., Ponce-de-León, C., Reade, G.W., and Walsh, F.C.: Reticulated vitreous carbon as an electrode material. J. Electroanal. Chem. 561, 203 (2004).Google Scholar
Farinos, R.M., Zornitta, R.L., and Ruotolo, L.A.M.: Development of three-dimensional electrodes of PbO2 electrodeposited on reticulated vitreous carbon for organic eletrooxidation. J. Braz. Chem. Soc., (2016). doi: 10.5935/0103-5053.20160162.Google Scholar
Andrade, L.S., Ruotolo, L.A.M., Rocha-Filho, R.C., Bocchi, N., Biaggio, S.R., Iniesta, J., García-García, V., and Montiel, V.: On the performance of Fe and Fe, F doped Ti–Pt/PbO2 electrodes in the electrooxidation of the Blue Reactive 19 dye in simulated textile wastewater. Chemosphere 66, 2035 (2007).Google Scholar
Dalmolin, C., Biaggio, S.R., Rocha-Filho, R.C., and Bocchi, N.: Preparation, electrochemical characterization and charge–discharge of reticulated vitreous carbon/polyaniline composite electrodes. Electrochim. Acta 55, 227 (2009).Google Scholar
Bard, A.J. and Faulkner, L.R.: Electrochemical Methods: Fundamentals and Applications (Chichester, New York, 1980); p. 718.Google Scholar
Gaunand, A. and Coeuret, F.: Potential distribution in flow-through. Electrochim. Acta 23, 1197 (1978).Google Scholar
Volkman, Y.: Optimization of the effectiveness of a three-dimensional electrode with respect to its ohmic variables. Electrochim. Acta 24, 1145 (1978).Google Scholar
Doherty, T., Sunderland, J.G., Roberts, E.P.L., and Pickett, D.J.: An improved model of potential and current distribution within a flow-through porous electrode. Electrochim. Acta 41, 519 (1996).Google Scholar
Newman, J.S.: Electrochemical Systems (Prentice Hall, Englewood Cliffs, 1991); p. 560.Google Scholar
Ruotolo, L.A.M. and Gubulin, J.C.: A factorial-design study of the variables affecting the electrochemical reduction of Cr(VI) at polyaniline-modified electrodes. Chem. Eng. J. 110, 113 (2005).CrossRefGoogle Scholar
Ruotolo, L.A.M. and Gubulin, J.C.: A mathematical model to predict the electrode potential profile inside a polyaniline-modified reticulate vitreous carbon electrode operating in the potentiostatic reduction of Cr(VI). Chem. Eng. J. 171, 170 (2011).Google Scholar
Martins, R., Britto-Costa, P.H., and Ruotolo, L.A.M.: Removal of toxic metals from aqueous effluents by electrodeposition in a spouted bed electrochemical reactor. Environ. Technol. 33, 1123 (2011).Google Scholar
Bemelmans, C., Okeef, T., and Cole, E.: Evaluation of electrodeposited lead dioxide. Bull. Electrochem. 12, 591 (1996).Google Scholar
Supplementary material: File

Farinos and Ruotolo supplementary material

Farinos and Ruotolo supplementary material

Download Farinos and Ruotolo supplementary material(File)
File 1.7 MB