Hostname: page-component-7479d7b7d-q6k6v Total loading time: 0 Render date: 2024-07-08T23:54:07.706Z Has data issue: false hasContentIssue false
  • English
  • Français

Surface Conductance of Sodium Bentonite in Water

Published online by Cambridge University Press:  01 January 2024

H. van Olphen  and
M. H. Waxman
H. van Olphen
Affiliation:
Shell Development Company, Exploration and Production Research Division, Houston, Texas, USA
M. H. Waxman
Affiliation:
Shell Development Company, Exploration and Production Research Division, Houston, Texas, USA
Get access Rights & Permissions [Opens in a new window]

Abstract

The concept of surface conductance and its role in the interpretation of the formation resistivity factor of reservoir rocks is reviewed.

The specific surface conductance of a clay is determined for four narrow particle-size fractions of sodium Wyoming bentonite in conductivity water. The values are derived from the specific conductance of gels of these clays on the basis of the picture of an idealized cubic network structure of the clay plates. The average surface conductance for internal and external surfaces of the bentonites is found to be 3.2 × 10−19 ohm−1, which is 0.55 × the value expected when all exchangeable ions are assigned their infinite dilution mobility. The data are independent of particle size.

In addition, conductivity data are presented for clay suspensions in a wide range of concentrations. In extremely dilute suspensions, the contribution of the clay to the conductivity when expressed per unit weight of clay (the so-called “weight conductance”) is smaller than expected from an independent movement of particle and counter ions. This is interpreted to be partly a result of both electrophoretic and relaxation retardation, indicating that the electrical double layer on sodium bentonite has a condensed character. Probably part of the counter ions are entirely immobilized by adsorption on the surface.

With increasing clay concentration, further compression of the double layer increases the retardation effects and a further decrease of the weight conductance is observed. A minimum is reached at a concentration of a few tenths of one percent clay at which, according to viscosity and light absorption data, particle interaction becomes apparent. At this point, immobilization of the particles and bridging between the electrodes gradually eliminate the retardation effects, and surface conductance takes over. The weight conductance increases gradually until a constant value is reached in a concentration range of 5 to 12 g of clay per 100 ml gel, from which the above value of the specific surface conductance was computed.

Type
Article
Information
Clays and Clay Minerals (National Conference on Clays and Clay Minerals) , Volume 5 , February 1956 , pp. 61 - 80
Copyright
Copyright © Clay Minerals Society 1956

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Footnotes

Publication no. 110 Shell Development Company, Exploration and Production Research Division, Houston, Texas.

References

Behr, L., and Williams, A. J. Jr., 1932, The Campbell-Shackelton shielded ratio box: Proc. Radio Inst. Engs., v. 20, p. 969–988.Google Scholar
Bikerman, J. J., 1935, Oberflächenleitfähigkeit und ihre Bedeutung: Kolloid-Z, v. 72, p. 100–108.CrossRefGoogle Scholar
Cole, K. S., 1933, Surface conductance: Cold Spring Harbor symposia on quantitative biology, v. 1, p. 23–28. The Biological Laboratory, Cold Spring Harbor, N. Y., 229 p.CrossRefGoogle Scholar
Kahn, A., and Lewis, D. R., 1954, The size of sodium montmorillonite particles in suspension from electro-optical birefringence studies: J. Phys. Chem., v. 58, p. 801–804.Google Scholar
Kruyt, H. R., 1952, Colloid science, Part 1: Elsevier Publishing Co., New York, 389 p.Google Scholar
Marshall, C. E., 1949, The colloid chemistry of the silicate minerals: Academic Press Inc., New York, N. Y., 181 p.Google Scholar
Overbeek, J. Th. G., 1941, 1943, Theorie der Electrophorese, het Relaxatie Effect: Thesis, Utrecht, 1941, Chapter VII. Also, Kolloid Beihefte, v. 54, p. 287–364.Google Scholar
Patnode, H. W., and Wyllie, M. R. J., 1950, The presence of conductive solids in reservoir rock as a factor in electric log interpretation: A.LM.E. Trans., v. 189, p. 47–52.Google Scholar
Philippoff, W., 1942, Viskosität der Kolloide: Theodor Steinkopf, 453 p.Google Scholar
Rutgers, A. J., Facq, L., and van der Minne, J. L., 1949, Microscopic electrophoresis cell: Nature, v. 166, p. 100.CrossRefGoogle Scholar
Tattje, P. E. E., 1942, Beweeglijkheden van Ionen in het AgJ Sol (Mobilities of Ions in the AgI Sol): Thesis, Utrecht.Google Scholar
van Olphen, H., 1954, Interlayer forces in bentonite: in Clays and Clay Minerals, Nat. Acad. Sci.—Nat. Res. Council pub. 327, p. 418–438.Google Scholar
van Olphen, H., 1956, Forces between suspended bentonite particles: In Clays and Clay Minerals, Nat. Acad- Sci.—Nat. Res. Council pub 456, p. 204–224.Google Scholar
Winsauer, W. O., and McCardell, W. M., 1953, Ionic double-layer conductivity in reservoir rock: A.I.M.E. Trans., v. 198, p. 129–134.Google Scholar