Hostname: page-component-7479d7b7d-c9gpj Total loading time: 0 Render date: 2024-07-13T10:33:21.811Z Has data issue: false hasContentIssue false
  • English
  • Français

Mean Flow and Pressure in a Straight Suction Duct with Porous Walls

Published online by Cambridge University Press:  07 June 2016

F. M. Burrows
F. M. Burrows*
Affiliation:
Engineering Laboratory, University of Cambridge*
Get access

Summary

The mean flow of an incompressible fluid in a straight suction duct with porous walls is considered and relations between the inflow and the pressure difference required to produce it are established on the basis of an elementary momentum analysis. It is assumed that bom the velocity and the pressure across planes normal to the direction of the mean flow inside the duct are distributed uniformly everywhere and that the effect of obstructions, which do not alter significantly the area of the duct cross section at any position, can be described in terms of losses of total pressure which are proportional to the square of the local speed within the duct. A variety of cases is discussed and it is shown that calculation of the internal pressure is straightforward and in agreement with experiment, at least for the case of a pipe having uniform porosity.

Type
Research Article
Information
Aeronautical Quarterly , Volume 21 , Issue 2 , May 1970 , pp. 101 - 120
Copyright
Copyright © Royal Aeronautical Society. 1970

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Burrows, F. M. On some problems concerning high lift suction aircraft. PhD Dissertation, University of Cambridge, 1961.Google Scholar
2. Head, M. R. The boundary layer with distributed suction. ARC R & M 3025, 1955.Google Scholar
3. Hoerner, S. F. Fluid-dynamic drag. Hoerner, New York, 1958.Google Scholar
4. Horlock, J. H. An investigation of the flow in manifolds with open and closed ends. Journal of the Royal Aeronautical Society, Vol. 60 p. 749, 1956.CrossRefGoogle Scholar
5. Preston, J. H. The three-quarter radius pitot-tube flowmeter. The Engineer, Vol. 190 p. 400, 1950.Google Scholar