Hostname: page-component-7c8c6479df-ws8qp Total loading time: 0 Render date: 2024-03-29T14:31:34.687Z Has data issue: false hasContentIssue false

In Situ X-Ray Diffraction of an Arc Weld Showing the Phase Transformations of Ti and Fe as a Function of Position in the Weld Performed at a Synchrotron

Published online by Cambridge University Press:  06 March 2019

Joe Wong
Affiliation:
Lawrence Livermore National Laboratory Chemistry and Materials Science Department Livermore, CA 94551, USA
J. W. Elmer
Affiliation:
Lawrence Livermore National Laboratory Chemistry and Materials Science Department Livermore, CA 94551, USA
P. A. Waide
Affiliation:
Lawrence Livermore National Laboratory Chemistry and Materials Science Department Livermore, CA 94551, USA
E. M. Larson*
Affiliation:
Department of Earth and Planetary Science, University of New Mexico Albuquerque, NM 87131, USA
*
Author to whom correspondence should be addressed.
Get access

Extract

The synchrotron x-ray source provides a unique opportunity to observe many “in-situ” processes. The formation of the “short-lived” intermediate species, Ta2C, during the combustion synthesis of TaC, has been observed and reported by monitoring the Bragg diffraction peaks of the reactants and products, Similarly, the synthesis of the ferroelectric material, BaTiO3, and subsequent phase transfonnation from cubic to tetragonal have also been investigated. These experiments would not have been possible without the high incident x-ray flux available at a synchrotron source.

Type
Research Article
Copyright
Copyright © International Centre for Diffraction Data 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Wong, Joe, Larson, E.M., Holt, J.B., Waide, P., Rupp, B. & Frahm, R., Science, 249,1406-9, (1990).Google Scholar
2. Frahm, R., Wong, Joe, Holt, J.B., Larson, E.M., Rupp, B. & Waide, P.A., Phys. Rev. B, 46(14), 9205-08, (1992).Google Scholar
3. Larson, E.M., Holt, J.B., Joe Wong, P.A. Waide & Rupp, B., J. Materials Research, 8(7),1533-41, 1993.Google Scholar
4. Larson, E.M., Wong, Joe, Holt, J.B., Waide, P. A. & Rupp, B., in preparation for Solid State Comm.Google Scholar