Hostname: page-component-84b7d79bbc-5lx2p Total loading time: 0 Render date: 2024-07-25T22:51:40.845Z Has data issue: false hasContentIssue false
  • English
  • Français

Application of Synchrotron and Flash X-Ray Topography to Improved Processing of Electronic Materials

Published online by Cambridge University Press:  06 March 2019

J.M. Winter Jr. ,
R.E. Green Jr.  and
K.A. Green
J.M. Winter Jr.
Affiliation:
Center for Nondestructive Evaluation The Johns Hopkins University Baltimore, Maryland, 21218, USA
R.E. Green Jr.
Affiliation:
Center for Nondestructive Evaluation The Johns Hopkins University Baltimore, Maryland, 21218, USA
K.A. Green
Affiliation:
Center for Nondestructive Evaluation The Johns Hopkins University Baltimore, Maryland, 21218, USA
Get access

Abstract

White beam transmission topography was used to image defect structures in gallium arsenide single crystal substrates representative of those used for microwave integrated circuit fabrication. A scanning topographic camera was developed for Beamline X-19C at the National Synchrotron Light Source. Acquiring film topographs within a particular range of scan rates and x-ray fluxes was found to produce distorted images. The distortions were shown to be thermoelastic, arising from inhomogeneous deposition of thermal energy through the absorption of residual x-rays. The problem could be circumvented using faster scans with some sacrifice in spatial resolution. Real time electrooptic topographs were recorded using x-ray fluxes about one percent of those used for the film topographs. The potential for reducing the flux requirement to even lower levels which would be accessible to flash x-ray generators is considered.

Type
IV. Lattice Defects and X-Ray Topography
Information
Advances in X-Ray Analysis , Volume 35 , Issue A: First Pacific-International Congress on X-ray Analytical Methods (PICXAM). Fortieth Annual Conference on Applications of X-ray Analysis, August 7-16, 1991 , 1991 , pp. 239 - 245
Copyright
Copyright © International Centre for Diffraction Data 1991

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Winter, J.M. Jr. and Green, R.E. Jr., “Characterization of Industrially Important Materials Using XHRay Diffraction Imaging Methods”, in Nondestructive Characterization of Materials, p. Holler et al, eds. pp.771-779, Springer-Verlag, N.Y. (1989).Google Scholar
2. Winter, J.M. Jr., Green, R.E. Jr., and Corak, W.S., “White Beam synchrotron X-Ray Topography of Gallium Arsenide”, Review of Progress in Quantitative Nondestructive Evaluation, 7B, D. O. Thompson and Chimenti, D.E., eds, pp.1153-1160, Plenum, N.Y.,(1988).Google Scholar
3. Winter, J.M. Jr. and Green, E.E. Jr., “Design of a Versatile Demountable Flash X-Ray Tube for Diffraction studies”, in Proceedings of the 1989 Flash Radiography Topical Conference, E. A. Webster and A. M. Kennedy, eds, pp. 70-81, Am. Defense Preparedness Assn., Arlington, VA., (1989).Google Scholar