Vermiculite is a common layered silicate clay mineral which has good adsorption and ion-exchange properties, and which is used to remove pollutants from groundwater. The adsorption by vermiculite from Heibei Province, China, of low-concentration ammonium in water was assessed here to evaluate the effects of adsorption time, particle size, adsorbent dose, pH, and temperature. Using Fourier-transform infrared spectroscopy, the concentration of NH4+ at 1430 cm−1 was evaluated after ammonium was adsorbed by vermiculite. Based on Langmuir-model analysis, the adsorption capacity of the Chinese vermiculite (in the particle-size range 0.025–0.075 mm) for ammonium was 18 mg/g after 3 h of equilibration. Optimal adsorption occurred at pH 6–7 and 60°C, which is different from that at high ammonium concentrations. Smaller particle-size fractions showed greater degrees of adsorption. Increase in Mg2+, K+, or Na+ concentrations influenced ammonium adsorption and, therefore, indicated that cation exchange was the mechanism for ammonium uptake from low-concentration solutions.

We present a theoretical asymptotic solution for high-speed transient flow through microporous media in this work by addressing the inertia effect in the high-pressure-difference pulse-decay process. The capillaric model is adopted, in which a bundle of straight circular tubes with a high length–radius ratio is used to represent the internal flow paths of microporous media so that the flow is described by a simplified incompressible Navier–Stokes equation based on the mean density, capturing the major characteristics of mass flow rate. By order-of-magnitude analysis and asymptotic perturbation, the inertial solution with its dimensionless criterion for the high-pressure-difference pulse-decay process is derived. To be compared with experimental data, the theoretical solution involves all three related effects, including the inertia effect, the slippage effect and the compressibility effect. A self-built experimental platform is therefore established to measure the permeability of microporous media by both pulse-decay and steady-state methods to validate the theoretical solution. The results indicate that the relative difference between two methods is less than 30 % even for permeability at as low as $48.2$ nD $(10^{-21}\,{\rm m}^2)$, and the present theoretical solution can accurately capture the inertia effect in the high-pressure-difference pulse-decay process, which significantly accelerates the measurements for ultra-low-permeability samples.

This study aimed to analyze the clinical effects of microdissection testicular sperm extraction (micro-TESE) surgery combined with an intracytoplasmic sperm injection (ICSI) regimen in the treatment of non-obstructive azoospermia (NOA) patients with different etiologies. In total, 128 NOA patients participated in this study, in which they received infertility treatment by micro-TESE surgery combined with an ICSI regimen, and all patients were divided into three groups [the Klinefelter syndrome (KS), the idiopathic and the secondary NOA groups]. In addition, the sperm retrieval rate (SRR), fertilization rate, embryo development status and clinical treatment effects were analyzed. Among the 128 NOA patients, the SRR of KS NOA patients was 48.65%, those of idiopathic and the secondary patients were 33.82% and 73.91%, respectively. Regardless of etiologies, there was no correlation with age, hormone value or testicular volume. Further analysis showed that the SRR of the KS group was positively related with testosterone (T) values, and the SRR of the secondary group had a positive relationship with follicle-stimulating hormone or luteinizing hormone values. In the subsequent clinical treatment, the retrieved sperm was subjected to ICSI and achieved good treatment effects, especially in the secondary group, and the implantation rate (55.56%) and clinical pregnancy rate (68.42%) were both higher than those of the idiopathic group (28.75% and 40.00%) and KS group (22.05% and 30.77%). Micro-TESE surgery combined with ICSI insemination is the most effective treatment regimen for NOA patients. The SRR of NOA patients with different etiologies are related to certain specific factors, and micro-TESE surgery seems to be the ideal and only way to have biological children.

To explore whether embryo culture with melatonin (MT) can improve the embryonic development and clinical outcome of patients with repeated cycles after in vitro fertilization/intracytoplasmic sperm injection (IVF/ICSI) failure, immature oocytes from controlled ovarian superovulation cycles were collected for in vitro maturation (IVM) and ICSI. The obtained embryos were cultured in 0, 10–11, 10–9, 10–7 and 10–5 M MT medium respectively, and 10–9 M was screened out as the optimal concentration. Subsequently, 140 patients who underwent failed IVF/ICSI cycles received 140 cycles of embryo culture in vitro with a medium containing 10–9 M MT, these 140 MT culture cycles were designated as the experimental group (10–9 M group), and the control group was the previous failed cycles of patients (0 M group). The results showed that the fertilization, cleavage, high-quality embryo, blastocyst, and high-quality blastocyst rates of the 10–9 M group were significantly higher than those of the 0 M group (P < 0.01; P < 0.01; P < 0.0001; P < 0.0001; P < 0.0001). To date, in total, 50 vitrified-warmed cycle transfers have been performed in the 10–9 M group and the implantation rate, biochemical pregnancy rate and clinical pregnancy rate were significantly higher than those in the 0 M group (all P < 0.0001). Two healthy infants were delivered successfully and the other 18 women who achieved clinical pregnancy also had good examination indexes. Therefore the application of 10–9 M MT to embryo cultures in vitro improved embryonic development in patients with repeated cycles after failed IVF/ICSI cycles and had good clinical outcomes.

Trial registration: ChiCTR2100045552.

To explore whether different polyvinylpyrrolidone (PVP) concentrations affect the results of intracytoplasmic sperm injection (ICSI), a prospective study was conducted for 194 couples undergoing 210 ICSI therapy cycles. These cycles were divided into three groups (10, 7 and 5% groups) using the corresponding concentration of PVP for sperm immobilization. The main outcome measures were analyzed. Results indicated that, with a decrease in PVP concentrations, all of the main outcome measures increased. In particular, the high-quality cleavage embryo rate in the 7% group was significantly lower than in the 5% group (P < 0.01), and the cleavage, high-quality cleavage embryo, and high-quality blastocyst rates in the 5% group were significantly higher than those in the 10% group (all P < 0.001). For high-/intermediate-quality semen, all of the main outcome measures were significantly increased with 5% PVP. For the poor-quality semen, only the high-quality cleavage embryo and high-quality blastocyst rates were significantly higher in the 5% group. Therefore, lowering PVP concentrations greatly promoted the development of embryos in ICSI cycles, with an optimal concentration of 5% for ICSI.

Remote sensing data, including those from Landsat Thematic Mapper/Enhanced Thematic Mapper Plus (TM/ETM +), the Shuttle Radar Topography Mission Digital Elevation Model (SRTM4.1 DEM), and the Geoscience Laser Altimeter System Ice, Cloud, and Land Elevation Satellite (Glas/ICESat), show that from 1991 to 2013 the glacier area in the Depuchangdake region of northwestern Tibet decreased from 409 to 393 km2, an overall loss of 16 km2, or 3.9% of the entire 1991 glacial area. The mean glacier-thinning rate was − 0.40 ± 0.16 m equivalent height of water per year (w.e./yr), equating to a glacier mass balance of − 0.16 ± 0.07 km3 w.e./yr. Total mass loss from 2003 to 2009 was − 1.13 ± 0.46 km3. Glacier retreat likely reflects increases in annual total radiation, annual positive degree days, and maximum temperature, with concurrent increases in precipitation insufficient to replenish glacial mass loss. The rate of glacier retreat in Depuchangdake is less than that for Himalayan glaciers in Indian monsoon-dominated areas, but greater than that for Karakoram glaciers in mid-latitude westerly-dominated areas. Glacier type, climate zone, and climate change all impact on the differing degrees of long-term regional glacial change rate; however, special glacier distribution forms can sometimes lead to exceptional circumstances.

Experimental studies have suggested that tea consumption could lower the risk of dyslipidaemia. However, epidemiological evidence is limited, especially in southern China, where oolong tea is the most widely consumed beverage. We conducted a population-based case–control study to evaluate the association between consumption of tea, especially oolong tea, and risk of dyslipidaemia in Shantou, southern China, from 2010 to 2011. Information on tea consumption, lifestyle characteristics and food consumption frequency of 1651 patients with newly diagnosed dyslipidaemia and 1390 controls was obtained using a semi-quantitative questionnaire. Anthropometric variables and serum biochemical indices were determined. Drinking more than 600 ml (2 paos) of green, oolong or black tea daily was found to be associated with the lowest odds of dyslipidaemia risk (P< 0·001) when compared with non-consumption, but only oolong tea consumption was found to be associated with low HDL-cholesterol levels. A dose–response relationship between duration of tea consumption and risk of dyslipidaemia (OR 0·10, 95 % CI 0·06, 0·16), as well as that between amount of dried tea leaves brewed and risk of dyslipidaemia (OR 0·34, 95 % CI 0·24, 0·48), was found. Moreover, consumption of oolong tea for the longest duration was found to be associated with 3·22, 11·99 and 6·69 % lower blood total cholesterol, TAG and LDL-cholesterol levels, respectively. In conclusion, the present study indicates that long-term oolong tea consumption may be associated with a lower risk of dyslipidaemia in the population of Shantou in southern China.

It is important to know the detailed DNA structure on carbonaceous surfaces for further application of DNA-functionalized carbonaceous materials in diverse research areas. In this study, the topographic and structural characteristics of the separated single DNA molecules and their assembly on highly oriented pyrolytic graphite (HOPG) surfaces have been investigated by atomic force microscopy (AFM). AFM results indicate that both circular and linear DNA molecules tend to form hexagonal patterns along with some unusual structures that include node, protrusion, cruciform, parallel single-stranded DNA (ssDNA), and compact zigzag. Furthermore, parallel ssDNA patterns and their crossed structures have been obtained under high-temperature conditions. Our AFM results reveal that a bare HOPG surface can induce DNA molecules to form various unusual structures. This finding is helpful for understanding the adsorption behavior of DNA on other carbonaceous surfaces such as carbon nanotubes and graphene. In addition, the hexagonal DNA patterns in this study are similar to those formed on the alkylamine-modified HOPG surface, which implies that a bare HOPG, without any chemical modification, has a strong ability to align biomolecules. This study could expand our knowledge of the diversities of DNA structures and the aligning ability of carbonaceous surfaces.

In shipborne Transfer Alignment (TA) applications, partial observability is one of the most important factors limiting convergence velocity. This paper proposes a new method of attributing weak observable states and lever-arm variables to a group of constraints in order to improve the observability of TA model. This yields the so-called Constrained Transfer Alignment (CTA) model which is uniformly observable even under zero-manoeuvre conditions. Within this framework, the Moving Horizon Estimation (MHE) and its stability analysis are also addressed. Finally, comparative simulation results are given to demonstrate the advantages of the proposed approach.

The influence of the density of gap states and the band gap width of the intrinsic a-Si:H active layer on the characteristics of a-Si PIN/OLED coupling pair was analyzed by a-Si:H PIN/OLED CAD simulation model. The CAD simulation model was carried out based on a-Si PIN Hack & Shur model and OLED TCL transport model. At the same band gap width, for the intrinsic a-Si:H active layer with the higher density of gap states, the reverse current of a-Si PIN trended to be saturated at the higher reverse bias voltage. As a result, I-V curve of a-Si PIN/OLED around the turn point Vt became smoother with the increase of the density of gap states. At the same state density, the light induced current of a-Si PIN increased against the band gap width, assuming the input light had the same spectrum as AM1.5 solar light. Thus the luminance emitted from OLED increased with the decrease of the band gap width because OLED belongs to the light-emitting device controlled by current. The simulation results also showed that the influence of the state density intensified with the increase of the band gap of a-Si:H.