Application of nitrogen (160 and 80 kg. N/ha.) and phosphate (80 and 40 kg. P2O5/ha.) increased the diameter and height of cane and number of shoots per metre of row, and consequently the yield of minable canes, with significant differences between the effects of the two levels of each nutrient. Potash did not affect the growth and yield of sugarcane. Application of 80 kg. P2O5/ha. was beneficial only with 160 kg. N/ha. but 40 kg. P2O5 proved effective with both 160 and 80 kg. N. because yield of millable cane with 80 kg. each of N and P2O5 was significantly lower than with 80 kg. N + 40 kg. P2O5.

Effect of small dose gamma-irradiation on electrical characteristics of AlGaN/GaN high electron mobility transistors has been investigated. Decreasing of the leakage current and its noise has been registered after dose of 1×106 Rad. As-grown heterostructures used in further for the device fabrication have been examined after the same radiation treatment. The small dose radiation results are explained within a model that takes into account relaxation of elastic strains and structural-impurity ordering occurring in the barrier layer under irradiation.

Hydrogen gas sensors based on Pt/GaN Schottky diode structures were fabricated and their responses to hydrogen were studied. These diodes were fabricated on Si doped GaN layer (ND = 1×1017). Three sets of diodes were fabricated with 80 Å, 240 Å and 400 Å of Pt for the Schottky contacts. The electronic performances of 0.25 × 0.25 mm devices were tested in up to 1 % H2 gas in synthetic air (79% N2, 21% O2) by volume. The devices were operated in constant current mode in a forward bias condition. The change in voltage was monitored with the diodes exposed to hydrogen and to dry air at varying temperatures. The responses increased as the thickness of the Schottky metal contact decreased at any given temperature up to 310 °C. The trend of increasing response with decreasing thickness was also observed in 0.5 × 0.5 mm and 1.0 × 1.0 mm size Schottky diodes. SEM studies of the microstructure showed that the thinner Pt devices had higher grain boundary densities. The increase in sensitivity with decreasing thickness points to the dissociation of molecular hydrogen on the surface, the diffusion of atomic hydrogen through the Pt grain boundaries and the adsorption of hydrogen to the surface as a possible mechanism of sensing of hydrogen by Schottky diodes.

In this work we present steady-state characteristics and low-frequency noise spectra of AlGaN/GaN based high electron mobility transistors (HEMTs) exposed to gamma ray radiation. The devices with a variety of gate length (150-350 nm) and width (100-400 νm) were irradiated by 60Co gamma rays with doses in the range of 104-109 Rad and flux of 102 Rad/s. Dose dependencies of basic operating parameters of the transistors, such as saturation current (Isat), transconductance (gm), channel conductance (gc), and threshold voltage (VT) are analysed. Our study show that visible changes of above mentioned parameters are observed under relatively small doses (105 Rad) and strongly depend on the HEMT's topology. The transconductance decreases and threshold voltage becomes more negative for all devices while deviation of these parameters from its initial values does not exceed 20% at highest irradiation dose. At the same time variation of the channel conductance as well as saturation current depends to a high extent on the gate voltage (Vg). At |Vg| < |Vcr|, both Isat and gc show a reversal proportional to the cumulative dosage of radiation. However, at |Vg| > |Vcr|, drain saturation current and channel conductance increase with the cumulative dosage of radiation. The effect is more pronounced in short-length-gate devices.

AlGaN/GaN is a promising system for high power electron devices. Quality of ohmic contacts is a critical parameter in determining the performance of the device. Although we have achieved a transfer resistance (Rc) of 0.35Δmm and ρc of 9.5×10−7 Δcm−2 the morphology and edge acuity of the contacts are poor. The standard ohmic contact recipes consist of a combination of Titanium and Aluminum with Nickel and/or Gold. This is annealed at 800°C-950°C [1-5]. In this work we study ohmic contacts on unintentionally doped Al0.3Ga0.7N/GaN system. We look at ratios of Ti/Al from 0 to 2 to determine which is the optimum ratio in terms of surface morphology and electrical characteristics. From our studies we conclude that morphology of a Ti/Al contact is good over a ratio of 0.3 and the contact resistance is minimized at a Ti/Al of 0.6. The ohmic contacts are improved electrically if a layer of gold is added on top. The best electrical contacts however were obtained with a four layer recipe of Ti/Al/Ti/Au, which gave contact resistance (Rc) around 0.45Δmm, but the morphology of the contacts was poor.

In this study thin AlxGa1−xN nucleation layers on sapphire were patterned and overgrown by plasma-induced molecular beam epitaxy (PIMBE) and metalorganic chemical vapor deposition (MOCVD) to obtain adjacent regions of GaN and AlGaN/GaN heterostructures with different polarities. The role of polarity on the structural and electrical properties of epitaxial layers and AlGaN/GaN heterostructures was investigated for samples grown on patterned AlN or GaN nucleation layers. Epitaxial GaN and AlGaN/GaN heterostructures grown on Al-face AlN or N- face GaN nucleation layers were found to be Ga-face or N-face, respectively, independent of the technique used for the overgrowth.

The strong spontaneous polarization and piezoelectric effects in the wurtzite IIInitride semiconductors lead to new possibilities for device design. In typical heterojunction field effect transistors these effects are used to create large electron concentrations at the AlGaN/GaN interface. However, we examine several other possible device structures which include heterojunctions of AlGaN, GaN, and InGaN. For example, we find the strong electric fields present in these structures allow us to create quantum wells greater than 1 eV deep. Both Ga-faced and N-faced materials are explored. The two-dimensional electron gas concentrations in these structures are found using a self-consistent 1-D Schrödinger-Poisson solver modified to incorporate the effects of spontaneous and piezoelectric polarization. The boundary conditions at the heterojunction interfaces and at the surface and substrate are discussed in detail. Electron concentrations are compared with those obtained experimentally through capacitance-voltage and Hall effect measurements.