Barnyardgrass and other troublesome weeds have become a major problem for producers in a flooded rice system. Cultural control options and more efficient herbicide applications have become a priority to increase efficiency and weed control in rice. This study aimed to determine the effects of row width and nozzle selection on spray coverage and weed control in a flooded rice system. A field experiment was conducted at 7 site-years (Lonoke, AR, in 2021 and 2022; Pine Tree, AR, in 2021 and 2022; Rohwer, AR, in 2022; and Stoneville, MS, in 2021 and 2022) as a randomized complete block split-plot design. Five nozzles (XR, AIXR, TTI, TTI60, and AITTJ60) (subplot factor) were used for herbicide applications, and plots were drill-seeded in four row widths (whole plot factor) (13, 19, 25, and 38 cm). A droplet size experiment was conducted to evaluate the droplet size and velocity of each nozzle type used in the field experiment. Overall, as row width increased, barnyardgrass density increased. The rice grown in a wider width took longer to generate canopy closure, allowing weed escapes in the crop. For example, the 13-cm width had a 12 percentage point canopy coverage increase compared to the 38-cm row width at the preflood timing resulting in a reduction of six barnyardgrass plants per square meter. The smallest droplet size-producing nozzle (XR) provided greater weed control throughout the study but is more prone to drift. The dual-fan nozzles (AITTJ60 and TTI60) had variable weed control impacts, and it was difficult to predict when this might occur; however, they did have increased deposits on water-sensitive cards compared to single-fan counterparts (AIXR and TTI). In conclusion, a narrower row width (e.g., 19-cm or less) and a smaller droplet size producing nozzle (XR) are optimal for barnyardgrass control in a flooded rice system.

Previous research has shown that glufosinate and nicosulfuron at low rates can cause yield loss to grain sorghum. However, research has not been conducted to pinpoint the growth stage at which these herbicides are most injurious to grain sorghum. Therefore, field tests were conducted in 2016 and 2017 to determine the most sensitive growth stage for grain sorghum exposure to both glufosinate and nicosulfuron. Field test were designed with factor A being the herbicide applied (glufosinate or nicosulfuron). Factor B consisted of timing of herbicide application including V3, V8, flagleaf, heading, and soft dough stages. Factor C was glufosinate or nicosulfuron rate where a proportional rate of 656 g ai ha−1 of glufosinate and 35 g ai ha−1 of nicosulfuron was applied at 1/10×, 1/50×, and 1/250×. Visible injury, crop canopy heights (cm), and yield were reported as a percent of the nontreated. At the V3 growth stage visible injury of 32% from the 1/10× rate of glufosinate and 51% from the 1/10× rate of nicosulfuron was observed. This injury was reduced by 4 wk after application (WAA) and no yield loss occurred. Nicosulfuron was more injurious than glufosinate at a 1/10× and 1/50× rate when applied at the V8 and flagleaf growth stages resulting in death of the shoot, reduced heading, and yield. Yield losses from the 1/10× rate of nicosulfuron were observed from V8 through early heading and ranged from 41% to 96%. Yield losses from the 1/50× rate of nicosulfuron were 14% to 16% at the flagleaf and V8 growth stages respectively. The 1/10× rate of glufosinate caused 36% visible injury 2 WAA when applied at the flagleaf stage, which resulted in a 16% yield reduction. By 4 WAA visible injury from either herbicide at less than the 1/10× rate was not greater than 4%. Results indicate that injury can occur, but yield losses are more probable from low rates of nicosulfuron at V8 and flagleaf growth stages.

A non-GMO trait called Inzen™ was recently commercialized in grain sorghum to combat weedy grasses, allowing the use of nicosulfuron POST in the crop. Inzen™ grain sorghum carries a double mutation in the acetolactate synthase (ALS) gene Val560Ile and Trp574Leu, which potentially results in cross-resistance to a wide assortment of ALS-inhibiting herbicides. To evaluate the scope of cross-resistance to Weed Science Society of America Group 2 herbicides in addition to nicosulfuron, tests were conducted in 2016 and 2017 at the Lon Mann Cotton Research Station near Marianna, AR, the Arkansas Agricultural Research and Extension Center in Fayetteville, AR, and in 2016 at the Pine Tree Research Station near Colt, AR. The tests included ALS-inhibiting herbicides from all five families: sulfonylureas, imidazolinones, pyrimidinylthiobenzoics, triazolinones, and triazolopyrimidines. Treatments were made PRE or POST to grain sorghum at a 1× rate for crops in which each herbicide is labeled. Grain sorghum planted in the PRE trial were Inzen™ and a conventional cultivar. Visible estimates of injury and sorghum heights were recorded at 2 and 4 wk after herbicide application, and yield data were collected at crop maturity. In the PRE trial, no visible injury, sorghum height reduction, or yield loss were observed in plots containing the Inzen™ cultivar. Applications made POST to the Inzen™ grain sorghum caused visible injury, sorghum height reduction, and yield loss of 20%, 13%, and 35%, respectively, only in plots where bispyribac-Na was applied. There was no impact on the crop from other POST-applied ALS-inhibiting herbicides. These results demonstrate that the Inzen™ trait confers cross-resistance to most ALS-inhibiting herbicides and could offer promising new alternatives for weed control and protection from carryover of residual ALS-inhibiting herbicides in grain sorghum.

Life on Earth spans a range of temperatures and exhibits biological growth rates that are temperature dependent. While the observation that growth rates are temperature dependent is well known, we have recently shown that the statistical distribution of specific growth rates for life on Earth is a function of temperature (Corkrey et al., 2016). The maximum rates of growth of all life have a distinct limit, even when grown under optimal conditions, and which vary predictably with temperature. We term this distribution of growth rates the biokinetic spectrum for temperature (BKST). The BKST possibly arises from a trade-off between catalytic activity and stability of enzymes involved in a rate-limiting Master Reaction System (MRS) within the cell. We develop a method to extrapolate quantile curves for the BKST to obtain the posterior probability of the maximum rate of growth of any form of life on Earth. The maximum rate curve conforms to the observed data except below 0°C and above 100°C where the predicted value may be positively biased. The deviation below 0°C may arise from the bulk properties of water, while the degradation of biomolecules may be important above 100°C. The BKST has potential application in astrobiology by providing an estimate of the maximum possible growth rate attainable by terrestrial life and perhaps life elsewhere. We suggest that the area under the maximum growth rate curve and the peak rate may be useful characteristics in considerations of habitability. The BKST can serve as a diagnostic for unusual life, such as second biogenesis or non-terrestrial life. Since the MRS must have been heavily conserved the BKST may contain evolutionary relics. The BKST can serve as a signature summarizing the nature of life in environments beyond Earth, or to characterize species arising from a second biogenesis on Earth.

The ability to integrate electrical functionality into textile garments is becoming increasingly desired for consumer devices, military applications and for companies with large distributed workforces. This technology has the potential to facilitate the transfer of information and increase efficiency in many arenas. One of the major hurdles that has hindered the wedding of electronics and clothing has been the need to wash the resulting garment. This paper describes a study of the long term effects of washing and dry-cleaning electrotextile elements.