The ability to prepare multiple cross-section transmission electron microscope (XTEM) samples from one XTEM sample of specific sub-10 nm features was demonstrated. Sub-10 nm diameter Si nanowire (NW) devices were initially cross-sectioned using a dual-beam focused ion beam system in a direction running parallel to the device channel. From this XTEM sample, both low- and high-resolution transmission electron microscope (TEM) images were obtained from six separate, specific site Si NW devices. The XTEM sample was then re-sectioned in four separate locations in a direction perpendicular to the device channel: 90° from the original XTEM sample direction. Three of the four XTEM samples were successfully sectioned in the gate region of the device. From these three samples, low- and high-resolution TEM images of the Si NW were taken and measurements of the NW diameters were obtained. This technique demonstrated the ability to obtain high-resolution TEM images in directions 90° from one another of multiple, specific sub-10 nm features that were spaced 1.1 μm apart.

Electrical interconnects in integrated circuits have shrunk to sizes in the range of 20–100 nm. Accurate measurements of the dimensions of these nanowires are essential for identifying the dominant electron scattering mechanisms affecting wire resistivity as they continue to shrink. We report a systematic study of the effect of line edge roughness on the apparent cross-sectional area of 90 nm Cu wires with a TaN/Ta barrier measured by conventional two-dimensional projection imaging and three-dimensional electron tomography. Discrepancies in area measurements due to the overlap of defects along the wire's length lead to a 5% difference in the resistivities predicted by the two methods. Tomography of thick cross sections is shown to give a more accurate representation of the original structure and allows more efficient sampling of the wire's cross-sectional area. The effect of roughness on measurements from projection images is minimized for cross-section thicknesses less than 50 nm, or approximately half the spatial frequency of the roughness variations along the length of the investigated wires.

Transmission Electron Microscopy (TEM) was used to analyze the interface between RF sputtered alumina thin films and (NiZn)Fe2O4 substrates. Bright field and dark field TEM images, High Resolution Electron Microscopy (HREM), and Selected Area Electron Diffraction (SAED) patterns provided direct evidence of eta-alumina crystalline regions near the filmsubstrate interface. The orientation and existence of the crystalline alumina phase was dependent on the substrate crystal orientation.