We examined a working hypothesis of sticky thermoelectric (TE) materials, which is inversely designed to mass-produce flexible TE sheets with lamination or roll-to-roll processes without electric conductive adhesives. Herein, we prepared p-type and n-type sticky TE materials via mixing antimony and bismuth powders with low-volatilizable organic solvents to achieve a low thermal conductivity. Since the sticky TE materials are additionally injected into punched polymer sheets to contact with the upper and bottom electrodes in the fabrication process, the sticky TE modules of ca. 2.4 mm in thickness maintained temperature differences of ca. 10°C and 40°C on a hot plate of 40 °C and 120°C under a natural-air cooling condition with a fin. In the single-cell resistance analysis, we found that 75∼150-µm bismuth powder shows lower resistance than the smaller-sized one due to the fewer number of particle-particle interfaces in the electric pass between the upper and bottom electrodes. After adjusting the printed wiring pattern for the upper and bottom electrodes, we achieved 42 mV on a hot plate (120°C) with the 6 x 6 module having 212 Ω in the total resistance. In addition to the possibility of mass production at a reasonable cost, the sticky TE materials provide a low thermal conductivity for flexible TE modules to capture low-temperature waste heat under natural-air cooling conditions with fins for the purpose of energy harvesting.

In order to evaluate the characteristics of photocatalysts such as TiO2, it is important to separately estimate the oxidation and reduction reaction rates, since the overall reaction rate is limited by the rate-determining step. In this study, photoelectrochemical techniques were applied to thin films of crystalline oriented anatase TiO2 with polycrystalline aggregations deposited on the transparent conductive oxide (TCO) glass substrate, fabricated by the electrophoretic deposition (EPD) in a strong magnetic field. The influence of the plane orientation on the photocatalytic reaction rates was discovered for both oxidation and reduction with respect to current through the electrochemical measurements. The maximum photocurrent for the (001) plane orientation is three times higher than that for the (100) plane orientation, and is comparable with that of the random orientation. The rate of the anodic reaction determines the rate of the overall photocatalytic reaction, therefore affecting the photopotential.

The influence of the crystalline orientation of the TiO2 photoanode on the photo-electrochemical characteristics was investigated to reveal the primary factors responsible for improving the photoelectric conversion efficiency of a dye-sensitized solar cell. It was observed that the photocurrent depended on the plane orientation, whereas the dependence of the photopotential on the open circuit was almost constant. The rate of the photoanodic reaction was attributed to the dye adsorption, depending on the surface energy of each oriented plane of the TiO2. The cathodic reaction on TiO2 during open circuit is likely to determine the rate of the entire electrochemical reaction.