The generalized theory of terawatt laser pulse interaction with a low-dense porous substance of light chemical elements including laser light absorption and energy transfer in a wide region of parameter variation is developed on the base of the model of laser-supported hydrothermal wave in a partially homogenized plasma. Laser light absorption, hydrodynamic motion, and electron thermal conductivity are implemented in the hydrodynamic code, according to the degree of laser-driven homogenization of the laser-produced plasma. The results of numerical simulations obtained by using the hydrodynamic code are presented. The features of laser-supported hydrothermal wave in both possible cases of a porous substance with a density smaller and larger than critical plasma density are discussed along with the comparison with the experiments. The results are addressed to the development of design of laser thermonuclear target as well as and powerful neutron and X-ray sources.

Results of experimental and computational investigations devoted to energy transfer mechanisms and X-ray conversion efficiency in laser-produced plasma are presented and discussed. The layers of different thicknesses and diameters deposited on the plane mylar substrate were irradiated by the focused beam of Nd:glass laser. Spectrally, temporally, and spatially resolved measurements of soft X-ray emission have been carried out at power densities of 1013-1014 W/cm2. The conditions of “re-emission” zone formation have been established. Radiative heat conductivity is shown to be the important energy transfer mechanism in the experimental conditions under investigation.

The dynamics of fast laser-induced vacuum discharge, with a rather small value of amplitude of current (≤ 10 kA), as well as the voltage and energy of the capacitor bank (≤ 20 kV and 20 J, respectively), have been investigated. It has been experimentally demonstrated that the initiations conditions determined by the energy and duration of the laser radiation, fundamentally determine the dynamics of the discharge. Two types of space and time separated plasma instabilities are revealed. It was found that the first of instabilities occurs at the initial stage of the discharge and is caused by a pinch structure, which takes place in front of a cathode jet extending in vacuum. The second type of instabilities arises at the top or recession of the current and is accompanied by the generation of hard (energy ≥100 keV) bremsstrahlung X-ray radiation from the anode area. The excess energy of the hard components of radiation over the potential of the current source is associated with the effects of plasma-erosive breaking.

An investigation of a monochromatic point X-ray source of photon energy ∼5 keV was carried out. The source was set up using a laser produced Al plasma as a cathode and a point-tip Ti anode. Optimum parameters of the diode were determined from experimental measurements of X-ray intensity dependence on laser pulse energy, applied accelerating voltage, and distance between target (cathode) and anode, using Nd:glass laser pulses (FWHM 30 ns) of 2 mJ to 4 J energy. Electron temperature characterization of the target plasma was also performed from the XUV emission spectrum (5–80 Å). Parameters of X radiation in Ti K-shells are (1) spectral brightness of ∼1020 photons/cm2-sec-sr-keV, (2) spatial size ∼300 microns, and (3) X-ray pulse duration less than 20 ns.

Experimental study of the radiation scattered at the laser heating of low-density foam targets and transmitted through the targets is presented. The scattered and transmitted radiations were investigated using spectrometers and streak cameras providing spatial, angular, spectral and temporal resolutions that enabled us to study the dynamics of the process of burning-through of the thick foam targets, the velocities of the plasma critical density motion as well as mass velocity of the plasma.