Hostname: page-component-7c8c6479df-fqc5m Total loading time: 0 Render date: 2024-03-28T18:19:19.666Z Has data issue: false hasContentIssue false

Ultrafast Pulsed Laser Deposition of Chalcogenide Glass Films for Low-loss Optical Waveguides

Published online by Cambridge University Press:  15 February 2011

B. Luther-Davies
Affiliation:
Laser Physics Centre, Research School of Physical Sciences and Engineering, theAustralian National University, Canberra, ACT 0200, Australia
V. Z. Kolev
Affiliation:
Laser Physics Centre, Research School of Physical Sciences and Engineering, theAustralian National University, Canberra, ACT 0200, Australia
M. J. Lederer
Affiliation:
Laser Physics Centre, Research School of Physical Sciences and Engineering, theAustralian National University, Canberra, ACT 0200, Australia
R. Yinlan
Affiliation:
Laser Physics Centre, Research School of Physical Sciences and Engineering, theAustralian National University, Canberra, ACT 0200, Australia
M. Samoc
Affiliation:
Laser Physics Centre, Research School of Physical Sciences and Engineering, theAustralian National University, Canberra, ACT 0200, Australia
R. A. Jarvis
Affiliation:
Laser Physics Centre, Research School of Physical Sciences and Engineering, theAustralian National University, Canberra, ACT 0200, Australia
A. V. Rode
Affiliation:
Laser Physics Centre, Research School of Physical Sciences and Engineering, theAustralian National University, Canberra, ACT 0200, Australia
J. Giesekus
Affiliation:
Fraunhofer Institute for Laser Technique, Steinbachstr. 15, D-52074 Aachen, Germany
K.-M. Du
Affiliation:
Fraunhofer Institute for Laser Technique, Steinbachstr. 15, D-52074 Aachen, Germany
M. Duering
Affiliation:
Fraunhofer Institute for Laser Technique, Steinbachstr. 15, D-52074 Aachen, Germany
Get access

Abstract

Ultra-fast pulsed laser deposition using high-repetition-rate short-pulse lasers has been shown to provide high optical quality, super smooth thin films free of scattering centres. The optimized process conditions require short ps or sub-ps pulses with repetition rate in the range 1-100 MHz, depending on the target material. Ultra-fast pulsed laser deposition was used to successfully deposit atomically-smooth, 5micron thick As2S3 films. The as-deposited films were photosensitive at wavelengths close to the band edge (≈520 nm) and waveguides could be directly patterned into them by photo-darkening using an Argon ion or frequency doubled Nd:YAG laser. The linear and nonlinear optical properties of the films were measured as well as the photosensitivity of the material. The optical losses in photo-darkened waveguides were <0.2 dB/cm at wavelengths beyond 1200nm and <0.1 dB/cm in as-deposited films. The third order nonlinearity, n2,As2S3, was measured using both four-wave mixing and the z-scan technique and varied with wavelength from 100 to 200 times fused silica (n2,Silica ≈3×10-16 cm2/W) between 1500nm and 1100nm with low nonlinear absorption.

Encouraged by the Ultrafast laser deposition results, we have built a new specialized modelocked picosecond laser system for deposition of optical films and for laser formation of nanoclusters. The newly developed “state of the art” powerful Nd:YVO laser can operate over a wide range of wavelengths, intensities, and repetition rates in MHz range. A brief description of the 50W laser installation is presented.

Type
Research Article
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

references

1. Asobe, M., “Nonlinear optical properties of chalcogenide glass fibers and their application to alloptical switching”, Optical Fiber Technology, 3, 142–148 (1997)Google Scholar
2. Owen, A. E., Firth, A.P. and Ewen, P.J.S., “Photo-induced structural and physico-chemical changes in amorphous chalcogenide semiconductors”, Phil. Mag. B, 52, 347–362 (1985)Google Scholar
3. Lenz, G., Zimmermann, J., Katsufuji, T., Lines, M.E., Hwang, H. Y., Spalter, S., Slusher, R.E., Cheong, S.W., Sanghera, J.S. and Aggarwal, I.D., “Large Kerr effect in bulk Se-based chalcogenide glasses”, Optics Letters, 25, 254256 (2000)Google Scholar
4. Viens, J-F, Meneghini, C., Villeneuve, A., Galstian, T.V., Knystautas, E.J., Duguay, M.A., Richardson, K.A. and Cardinal, T., “Fabrication and characterization of Integrated optical waveguides in sulfide chalcogenide glasses””, IEEE J. of Lightwave Technology, 17, 11841191 (1999)Google Scholar
5. Ramachandran, S. and Bishop, S.G., “Low loss photoinduced waveguides in rapid thermally annealed films of chalcogenide glasses”, Appl. Phys. Lett., 74, 1315 (1999)Google Scholar
6. Youden, K.E., Grevatt, T., Eason, R.W., Rutt, H. N., Deol, R.S. and Wylangowski, G., “Pulsed laser deposition of Ga-La-S chalcogenide glass thin film optical waveguides”, Appl. Phys. Lett. 63, 16011603 (1993)Google Scholar
7. Gill, D. S., Eason, R. W., Zaldo, C., Rutt, H. N. and Vainos, N. A., “Characterisation of Ga-La-S chalcogenide glass thin-film optical waveguides, fabricated by pulsed laser deposition”, J. Non-Crys. Sol., 191, 321326 (1995)Google Scholar
8. Rode, A.V., Luther-Davies, B. and Gamaly, E.G., “Ultrafast Ablation with High-Pulse-Rate Lasers. Part I: Theoretical Considerations”, J. Appl. Physics, 85, 42134221 (1999)Google Scholar
9. Rode, A.V., Luther-Davies, B. and Gamaly, E.G., “Ultrafast Ablation with High-Pulse-Rate Lasers. Part II: Experiments on Laser Deposition of Amorphous Carbon Films”, J. Appl. Physics, 85, 42224230 (1999)Google Scholar
10. Rode, A. V., Zakery, A., Samoc, M., Charters, R. B., Gamaly, E. G., and Luther-Davies, B., “Nonlinear As-S chalcogenide films for optical waveguide writing deposited by high-repetition-rate laser ablation”, Appl. Surf. Science 197-198, 481485 (2002)Google Scholar
11. Goldschmidt, D., “Determination of the absorption edge of a thin film from transmission measurements”, J. Opt. Soc. Am. A, 1, 275277 (1984)Google Scholar
12. Mott, N.F. and Davis, E.A., Electronic Processes in Non-Crystalline Materials, 2nd ed. (Oxford: Clarendon, 1979), p.289.Google Scholar
13. Sheik-Bahae, M., Said, A. A., Wei, T.-H., Hagan, T. D. J., Stryland, E. W. Van, E., “Sensitive measurement of optical nonlinearities using a single beam”, IEEE Journal of Quant. Electr, 26, 760769 (1990)Google Scholar
14. Samoc, M., Samoc, A., Luther-Davies, B., Bao, Z., Yu, L. and Scherf, U., “Femtosecond Z-scan and degenerate four-wave mixing measurements of real and imaginary parts of the third-order nonlinearity of soluble conjugated polymers”, J. Opt. Soc. Am. B, 15, 817825 (1998)Google Scholar
15. Kolev, V. Z., Lederer, M. J., Luther-Davies, B., and Rode, A. V., “Passive mode-locking of a Nd:YVO4 laser with an extra-long optical resonator”, accepted for publication in Optics Letters, April 2003.Google Scholar
16. Herriott, D., Kogelnik, H., and Kompfner, R., “Off-axis paths in spherical mirror interferometers,” Appl. Opt. 3, 523 (1964)Google Scholar
17. Keller, U., Miller, D. A. B., Boyd, G. D., Chiu, T. H., Ferguson, J. F., and Asom, M. T., “Solid-state lowloss intracavity saturable absorber for Nd:YLF lasers: an antiresonant semiconductor Fabry-Perot saturable absorber,” Opt. Lett. 17, 505 (1992)Google Scholar
18. Lederer, M. J., Kolev, V., Luther-Davies, B., Tan, H. H., and Jagadish, C., “Ion-implanted InGaAs single quantum well semiconductor saturable absorber mirrors for passive mode-locking,” J. Phys. D: Appl. Phys. 34, 2455 (2001)Google Scholar