Hostname: page-component-7c8c6479df-p566r Total loading time: 0 Render date: 2024-03-28T12:55:30.593Z Has data issue: false hasContentIssue false

Relationship Between Plasma Chemistry and Electron Trapping rate in Plasma-Deposited Silicon Nitride

Published online by Cambridge University Press:  16 February 2011

Donald L Smith*
Affiliation:
Xerox Palo Alto research Center, 3333 Coyote Hill Road, Palo Alto, CA 94304
Get access

Abstract

Silicon nitride deposited by plasma-enhanced chemical vapor deposition (PECVD) from SiH4 and NH3 is not crystalline Si3N4 with a specific stoichiometric ratio, but rather SiNxHy, an Amorphous network in which the N/Si ratio can vary from zero in Amorphous Si (a-Si) to almost two. The rate at which injected electrons are trapped in SiNxHy decreases by over 103 when N/Si is increased from 4/3 to the N saturation point, and the trapping centers are therefore likely to be Si dangling bonds. Trapping is undesirable in semiconductor devices except in memory applications, because it shifts the device's flat-band voltage, although in a-Si thin-film transistors (TFT's) the nitride trapping rate can easily be made Much smaller than the rate of electron trapping in deep states of the a-Si. When deposition plasma chemistry is driven to the N-saturation point, SiNxHy has a trapping rate lower than that of the best PECVDSiO2, although this is still 104 above that of thermal oxide grown on single-crystal Si. N-saturated deposition requires not only a high NH3/'SiH4 feed ratio, but also sufficient plasma power to activate the NH3 so that it will completely consume the SiH4 in formation of the tetra-aminosilane [Si (NH2) 4] precursor molecule. Then, the Si in the Amorphous network becomes entirely bonded to N rather than to both H and N, and NH groups act like O does in SiO2 to lower the coordination of the network and thus avoid dangling bonds.

Type
Research Article
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Smith, D. L., J. Vac. Sci. Technol. A 11, 1843 (1993)Google Scholar
2. Park, Y. C., Jackson, W. B., Smith, D. L., and Johnson, N. M., J. Appl. Phys. 74, 381 (1993)Google Scholar
3. Phillips, J. C., J. Non-Cryst. Solids 34, 153 (1979)Google Scholar