Hostname: page-component-848d4c4894-tn8tq Total loading time: 0 Render date: 2024-06-28T18:56:41.477Z Has data issue: false hasContentIssue false
  • English
  • Français

In-Situ Characterisation of Photo-actuating and Photo-rheological Polymers

Published online by Cambridge University Press:  01 February 2011

Chris J. Sabey ,
M. Moniruzzaman ,
Gerard F. Fernando ,
Rodney A. Badcock ,
Darren Winter ,
Jackie Akhavan ,
Esam Kronfli  and
A. Bandara
Chris J. Sabey
Affiliation:
Cranfield University, RMCS Shrivenham, Swindon, United Kingdom
M. Moniruzzaman
Affiliation:
Cranfield University, RMCS Shrivenham, Swindon, United Kingdom
Gerard F. Fernando
Affiliation:
Cranfield University, RMCS Shrivenham, Swindon, United Kingdom
Rodney A. Badcock
Affiliation:
Cranfield University, RMCS Shrivenham, Swindon, United Kingdom
Darren Winter
Affiliation:
Cranfield University, RMCS Shrivenham, Swindon, United Kingdom
Jackie Akhavan
Affiliation:
Cranfield University, RMCS Shrivenham, Swindon, United Kingdom
Esam Kronfli
Affiliation:
Cranfield University, RMCS Shrivenham, Swindon, United Kingdom
A. Bandara
Affiliation:
Kingston University, Kingston-upon-Thames, Surrey, United Kingdom
Get access

Abstract

This paper reports on the design and validation of three in-situ measurement techniques for characterisation of photo-rheological and photo-actuation phenomena. Results from these in-situ techniques are presented and used to investigate isomerisation and recovery effects in azobenzene and spiropyran polymer systems with and without flexible spacer groups.

A new in-situ technique for the measurement of photo-viscosity effects in polymer solutions has been developed using a cone and plate rheometer. The new technique permits simultaneous irradiation of the photo-responsive polymer solutions and continuous measurement of its viscosity in a controlled environment. An additional benefit of the technique is the greatly reduced sample volume compared to traditional capillary viscometers.

Techniques for the in-situ measurement of the photo-actuation effect in polymer systems are discussed, including image analysis and interferometric methods. The effects of environmental factors such as temperature are considered and steps taken to minimise them. The resulting measurement techniques provide an accurate means of measuring the effect of irradiation on the photo-actuating polymers in solution and as solids.

A range of polymers with photo-responsive azobenzene and spiropyran groups in the polymer side chains have been synthesised and evaluated using these three techniques. The photoviscosity and photo-actuation effects under irradiation have been measured in a variety of solvents. The effect of incorporating a flexible spacer group in the side chain of the azobenzene polymers is examined and its effect on the photo-rheology mechanism is discussed.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 785: Symposium D – Materials and Devices for Smart Systems , 2003 , D8.8
Copyright
Copyright © Materials Research Society 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Irie, M., Advances in Polymer Science, 1990. 94: p. 27–67.10.1007/BFb0043060Google Scholar
2. Lovrien, R., Proc. of the National Academy of Science Chemistry, 1967. 57: p. 236–242.10.1073/pnas.57.2.236Google Scholar
3. Pieroni, O. and Ciardelli, F., Trends in Polymer Science, 1995. 3(9): p. 282–287.Google Scholar
4. Matejka, L. and Dusek, K., Makromolekulare Chemie-Macromolecular Chemistry and Physics, 1981. 182(11): p. 3223–3236.10.1002/macp.1981.021821128Google Scholar
5. Merian, E., Textile Research Journal, 1966. 36: p. 612–618.10.1177/004051756603600704Google Scholar
6. Blair, H.S. and Law, T.K., Polymer, 1980. 21: p. 1475–1476.10.1016/0032-3861(80)90150-0Google Scholar
7. Eisenbach, C.D., Polymer, 1980. 21: p. 1175–1179.10.1016/0032-3861(80)90083-XGoogle Scholar
8. Blair, H.S. and Pogue, H.I., Polymer, 1982. 23(5): p. 779–783.10.1016/0032-3861(82)90070-2Google Scholar
9. Gonzalez-de, los Santos, E.A., Lozano-Gonzalez, M.J., and Johnson, A.F., J. Appl. Poly. Sci., 1999. 71(2): p. 267–272.10.1002/(SICI)1097-4628(19990110)71:2<267::AID-APP10>3.0.CO;2-Z3.0.CO;2-Z>Google Scholar
10. Smets, G., Breaken, J., and Irie, M., Pure Appl. Chem., 1978. 50: p. 845–856.10.1351/pac197850080845Google Scholar
11. Degamber, B. and Fernando, G.F., J. Appl. Poly. Sci., 2003. 89(14): p. 3868–3873.10.1002/app.12586Google Scholar
12. Badcock, R., Fernando, G.F., and Ralph, B., Optical sensor device, UK Patent GB2283567B.Google Scholar