Hostname: page-component-848d4c4894-4rdrl Total loading time: 0 Render date: 2024-07-07T18:48:11.586Z Has data issue: false hasContentIssue false

Deformation Microstructure of Cold Gas Sprayed Coatings

Published online by Cambridge University Press:  18 March 2011

C. Borchers
Affiliation:
University of the Federal Armed Forces, Dept. Maschinenbau, Hamburg, Germany
T. Stoltenhoff
Affiliation:
University of the Federal Armed Forces, Dept. Maschinenbau, Hamburg, Germany
F. Gäartner
Affiliation:
University of the Federal Armed Forces, Dept. Maschinenbau, Hamburg, Germany
H. Kreye
Affiliation:
University of the Federal Armed Forces, Dept. Maschinenbau, Hamburg, Germany
H. Assadi
Affiliation:
Dept. of Materials Science Engineering, Tarbiat Modarres University, Tehran, Iran
Get access

Abstract

Cold Gas Spraying is a new coating technique, in which the formation of dense, tightly bonded coatings occurs only due to the kinetic energy of high velocity particles of the spray powder. These particles are still in the solid state as they impinge on the substrate. Adiabatic heating after impingement can cause local shear instabilities and jet formation. The local microstructure is strongly dependant on local stress state and temperature rise. A variety of different microstructures is observed by TEM. The results are compared with modelling of the spray process.

Type
Research Article
Copyright
Copyright © Materials Research Society 2001

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Alkhminov, A.P., Klinkov, S.V., Kosarev, V.F. and Papyrin, A.N., J.appl.mech.tech.phys. 38, 324 (1997)Google Scholar
[2] Alkhminov, A.P., Kosarev, V.F. and Papyrin, A.N., J.appl.mech.tech.phys. 39, 318 (1998)Google Scholar
[3] Stoltenhoff, T., Richter, H., Kreye, H., submitted to J.Thermal Spray Techn. Google Scholar
[4] Kreye, H., Wdg.J.Res.Suppl. 56, 154 (1977)Google Scholar
[5] Kreye, H., Wittkamp, I. and Richter, U. Z.Metallkunde 67, 141 (1976)Google Scholar
[6] Kittel, C., Introduction to Solid State Physics, 5th ed. (John Wiley & Sons, New York, 1976)Google Scholar
[7] Byrne, J.G. Recovery, Recrystallization and Grain Growth (MacMillan, New York 1965), p.66 Google Scholar
[8] Haasen, P. Physical Metallurgy, 3rd ed. (Cambridge University Press, Cambridge 1996), p.392 Google Scholar