Hostname: page-component-8448b6f56d-t5pn6 Total loading time: 0 Render date: 2024-04-23T15:56:57.220Z Has data issue: false hasContentIssue false
  • English
  • Français

Conversion of Alkoxide Solutions to Oxides: Evaporation of Products

Published online by Cambridge University Press:  21 February 2011

R. A. Lipeles  and
D. J. Coleman
R. A. Lipeles
Affiliation:
Chemistry and Physics Laboratory, The Aerospace Corporation, El Segundo, CA 90245
D. J. Coleman
Affiliation:
Chemistry and Physics Laboratory, The Aerospace Corporation, El Segundo, CA 90245
Get access

Abstract

The evaporation of organic by-products released during drying of 1-mm thick silicon tetramethoxide gels was analyzed using gas chromatography. The evaporation kinetics of methanol depended on the drying rate achieved by flowing dry air over the gel. For drying at flow rates less than 50 cm 3/min, exponential kinetics were observed initially with a long time constant (about 100- to 400-min). For drying rates greater than 70 cm3/min, diffusional (t−1/2) kinetics were observed initially. Cracking of the gel during drying was used to indicate the degree of stress. At low drying rates, minor cracking was observed near the edges of the gel. At high flow rates, extensive cracking was observed in samples that exhibited early t−1/2 kinetics. Monitoring the kinetics of drying is essential to optimizing the drying conditions to minimize stress and cracking in gels.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 155: Symposium L – Processing Science of Advanced Ceramics , 1989 , 163
Copyright
Copyright © Materials Research Society 1989

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Shaw, T. M., in Better Ceramics Through Chemistry II, edited by Brinker, C. J.. Clark, , and Ulrich, D. R., (Mater. Res. Soc. Symp. Proc. 73, Pittsburgh, PA 1986) pp. 215–223.Google Scholar
2. Zarzycki, J., in Ultrastructure Processing of Ceramics, Glasses, and Composites, edited by Hench, L. L. and Ulrich, D. R., (John Wiley & Sons, Inc., New York, NY 1984) pp. 27–42.Google Scholar
3. Klein, L. C. and Garvey, G. J., in Ultrastructure Processing of Ceramics, Glasses, and Composites, edited by Hench, L. L. and Ulrich, D. R., Eds. John Wiley & Sons, Inc., New York, NY, 1984) pp. 88–99.Google Scholar
4. Scherer, G. W., in Better Ceramics Through Chemistry II, edited by Brinker, C. J., Clark, D. E., and Ulrich, D. R., (Mater. Res. Symp. Proc. 73, Pittsburgh, PA 1986) pp. 225–236.Google Scholar
5. Ford, R. W., Drying, Inst. of Ceramics Textbook Series, Vol 3, (Maclaren, London, 1964).Google Scholar
6. Scherer, G. W., J. Non-Crystal. Solids, 100, 77–92 (1988).Google Scholar
7. Glang, R., Holmwood, R. A., and Kurtz, J. A., in Handbook of Thin Film Technology, edited by Maissel, L. I. and Glang, R., (McGraw-Hill, New York, NY 1970) pp. 2–39 to 2–59Google Scholar