Hostname: page-component-8448b6f56d-dnltx Total loading time: 0 Render date: 2024-04-19T02:20:05.416Z Has data issue: false hasContentIssue false
  • English
  • Français

Combined Simulation and Measurement Study of Temperature Uniformity in Rapid Thermal Processing

Published online by Cambridge University Press:  21 February 2011

Yur-Tsai Lin ,
Ravi Subrahmanyan  and
A. R. Sitaram
Yur-Tsai Lin
Affiliation:
Marius Orlowski Motorola, Inc., APRDL, 3501 Ed Bluestein Blvd., MS:K10, Austin, TX 78721
Ravi Subrahmanyan
Affiliation:
Marius Orlowski Motorola, Inc., APRDL, 3501 Ed Bluestein Blvd., MS:K10, Austin, TX 78721
A. R. Sitaram
Affiliation:
Marius Orlowski Motorola, Inc., APRDL, 3501 Ed Bluestein Blvd., MS:K10, Austin, TX 78721
Get access

Abstract

Modeling and simulation of rapid thermal processing has been studied extensively in the past. This work presents the results of a combined simulation and measurement study of a commercial multilamp RTP chamber. The simulations were used to estimate the contributions of different geometrical, material, process, and physical effects on temperature uniformity. The physical effects considered in the simulations included radiation, thermal conduction, transient effects during ramp up and cool down and the effects of patterns on the wafer surface. The effects were corroborated by direct temperature measurements using thermocouple embedded wafers, and the results were used to reliably calculate stress effects. The stress distributions were determined analytically in cases without surface films on the wafer. In the case of wafers with surface films, stress distributions were calculated based on thermal strains. This study allows us to concentrate efforts on increasing temperature uniformity to those areas where the greatest benefits in terms of yield and film uniformity can be obtained.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 303: Symposium G – Rapid Thermal and Integrated Processing II , 1993 , 231
Copyright
Copyright © Materials Research Society 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Hill, C., Jones, S., and Boys, D., in Reduced Thermal Processing for ULSI, (Plenum, New York, 1989).Google Scholar
[2] Lord, H.A., IEEE Trans. Semiconductor Manufacturing, 1 (3) 105 1989.Google Scholar
[3] Kersch, A., Schafer, H., and Werner, C., in Proc. International Electron Devices Meeting, page 883, 1991 Google Scholar
[4] FIDAP Users Manual, Fluid Dynamic International, 1992.Google Scholar
[5] Lin, Y-T., “Temperature Uniformity in Rapid Thermal Processing Equipment”, Motorola (APRDL) Internal Report, 1992.Google Scholar
[6] Kakoschke, R. in Mat. Res. Soc. Proc., 1991 Google Scholar
[7] Vandenabeele, P., Maex, K., and DeKeersmaecker, R., MRS Spring Meeting, Symposium B, 1989.Google Scholar
[8] Seithoff, H. and Haasen, P., in Lattice Defects in Semiconductors, p. 491, Univ. of Tokyo, 1968.Google Scholar