Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-12-08T22:08:25.614Z Has data issue: false hasContentIssue false

POST‐METALLIZATION ANNEALING OF ULTRA‐THIN REMOTE PLASMA ENHANCED CVD OXIDES

Published online by Cambridge University Press:  10 February 2011

L‐Å Ragnarsson
Affiliation:
Department of Solid State Electronics, Chalmers University of Technology, S‐412 96 Göteborg Sweden, loke@ic.chalmers.se, per@ic.chalmers.se
P. Lundgren
Affiliation:
Department of Solid State Electronics, Chalmers University of Technology, S‐412 96 Göteborg Sweden, loke@ic.chalmers.se, per@ic.chalmers.se
D. Landheer
Affiliation:
Department of Solid State Electronics, Chalmers University of Technology, S‐412 96 Göteborg Sweden, loke@ic.chalmers.se, per@ic.chalmers.se Institute for Microstructural Sciences, National Research Council of Canada, Ottawa, Canada K1 A 0R6
Get access

Abstract

A remote plasma enhanced chemical vapour deposition (RPECVD) process was used to deposit thin silicon dioxides on silicon substrates. The oxide properties were compared with thermal oxides with similar thicknesses (2.5–9 nm) using capacitance‐voltage (C‐V), current‐voltage (I‐V) and constant voltage stress measurements (I‐t). Post‐metallization annealing (PMA) showed different annealing dynamics as compared to the thermal oxides for anneal times below approximately 1000 s (at 260 °C) after which the dynamics were similar. The deposited oxides had a higher initial interface state density (Dit) than the thermal oxides, but after PMA they were found to be of the same quality as the thermal oxides. Positive charging of the deposited oxides during constant voltage stress was the same as for thermal oxides, showing that the stress endurance of the two are similar.

Type
Research Article
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Lee, D. R., Hattangady, S. V., Niimi, H., Parker, C., Lucovsky, G., and Hauser, J. R., Microelectronic Engineering 28, 117120 (1995).Google Scholar
2 Parker, C. G., Silvestre, C. L., and Hauser, J. R., Microelectronic Engineering 28, 137140 (1995).Google Scholar
3 Lucovsky, G., Advanced Materials for Optics and Electronics 6, 5572 (1996).Google Scholar
4 Lucovsky, G., Niimi, H., Koh, K., Lee, D. R., and Jing, Z., in The Physics and chemistry of SiO2 and the Si‐SiO2 Interface ‐ 3, Los Angeles, 1996 (The Electrochemical Society proceedings series, Pennington, NJ), Vol. 96–1, p. 441–455.Google Scholar
5 Lundgren, P., Andersson, M. O., and Farmer, K. R., J. Appl. Phys. 74, 4780 (1993).Google Scholar
6 Andersson, M. O., Lundgren, P., Engström, O., and Farmer, K. R., Micorelectronic Engineering 22, 235238 (1993).Google Scholar
7 Andersson, M. O., Lundgren, A., and Lundgren, P., Phys. Rev. B 50, 11666 (1994).Google Scholar
8 Reed, M. L. and Plummer, J. D., J. Appl. Phys. 63, 57765793 (1988).Google Scholar
9 Ragnarsson, L.‐Å., Lundgren, P., Ovuka, Z., and Andersson, M. O., in The Physics and chemistry of SiO2 and the Si‐SiO2 Interface ‐ 3, Los Angeles, 1996 (The Electrochemical Society proceedings series, Pennington, NJ), Vol.96–1, p. 667676.Google Scholar
10 Lucovsky, G., Ma, Y., Yasuda, T., Silvestre, C., and Hauser, J. R., Jpn. J. of Appl. Phys. Part 1 31, 43874395 (1992).Google Scholar
11 Farmer, K. R., Andersson, M. O., and Engström, O., Appl. Phys. Lett. 60, 730732 (1992).Google Scholar