Hostname: page-component-594f858ff7-r29tb Total loading time: 0 Render date: 2023-06-08T08:07:51.584Z Has data issue: false Feature Flags: { "corePageComponentGetUserInfoFromSharedSession": true, "coreDisableEcommerce": false, "corePageComponentUseShareaholicInsteadOfAddThis": true, "coreDisableSocialShare": false, "useRatesEcommerce": true } hasContentIssue false

Photonic Crystal Structures as Spectral Control for Thermophotovoltaic Energy Conversion

Published online by Cambridge University Press:  31 January 2011

Patrick Michael Fourspring*
Affiliation:, Bechtel Marine Propulsion Corporation, 2401 River Road, Niskayuna, New York, 12309, United States, 5183956563, 5183956136
Get access


Spectral control is an enabling technology for greater than 10% efficient thermophotovoltaic (TPV) energy conversion [1-3]. Without control of the spectral distribution of photons reaching a TPV cell, the efficiency of a TPV energy conversion system suffers dramatically. Spectral control is the selection, design, and development of materials and structures used in TPV energy conversion systems to maximize the net flux of convertible (above band gap) photons, minimize the net flux of unconvertible (below band gap) photons, and recuperate (or reflect) any net flux of unconvertible (below band gap) photons that reach the TPV cell back to the radiating surface. Front surface, tandem filters consisting of an edge pass filter (short pass) in series with a highly doped, epitaxially grown layer have achieved the highest energy weighted spectral efficiency to date.

The performance, however, of these tandem filters is limited by at least two fundamental physical phenomena: the variation in performance with the incident angle of the photons and absorption in the filter materials. Three dimensional (3D), photonic crystal structures offer a potential solution to these fundamental limitations of tandem filters as well as the potential of spectral control for the radiating surfaces of TPV energy conversion system. First, 3D photonic crystal structures, in theory, perform equally for all incident angles. Second, the fabrication techniques for 3D photonic crystal structures may allow the use of materials (such as crystalline Si) with less absorption in the spectral range of interest (1-15μm) than the materials currently used in tandem filters. The fabrication techniques for 3D photonic crystal structures may also allow the use of high temperature (1000°C) materials for use as radiating surface spectral control. If so, 3D photonic crystal structures may be used to mitigate several of the inefficiencies associated with TPV systems.

The conclusion of this assessment is that 3D, photonic crystal structures can, in theory, provide near perfect TPV spectral control. If so, these structures may allow a 20% improvement over the performance achieved by tandem filters. Realizing this potential for TPV spectral control, however, will likely require significant development. At least two major challenges exist:

• Design techniques will likely need to be developed that will allow the analysis and design of 3D photonic crystal structures.

• Fabrication techniques will need to be developed for these structures that provide sufficient fidelity to a design to achieve the required performance and can be scaled to provide the area required for a given TPV application.

Research Article
Copyright © Materials Research Society 2009

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)


1 Baldasaro, P.F. et al. , Thermodynamic Analysis of Thermophotovoltaic Efficiency and Power Density Tradeoffs. Journal of Applied Physics, 2001. 89: p. 33193327.CrossRefGoogle Scholar
2 Fourspring, P.M. et al. Thermophotovoltaic Spectral Control. in 6th International Conference on the Thermophotovoltaic Generation of Electricity (TPV6). 2004. Frieburg, Germany: AIP.Google Scholar
3 DePoy, D.M. et al. Thermophotovoltaic Spectral Control. in International Energy Conversion Engineering Conference. 2004. Providence, RI, USA: AIAA.Google Scholar
4 Joannopoulos, J.D. Meade, R.D. and Winn, J.N. Photonic Crystals: Molding the Flow of Light. 1995.Google Scholar
5 Sakoda, K. Optical Properties of Photonic Crystals. 2001: Springer.CrossRefGoogle Scholar
6 Ribbing, C.-G., Photonic Structures as Interference Devices, in Optical Interference Coatings, Kaiser, N. and Pulker, H.K. Editors. 2003.CrossRefGoogle Scholar
7 Joannopoulos, J.D. Private Communication. 2004.Google Scholar
8 Johnson, S.G. and Joannopoulos, J.D. Three-dimensionally periodic dielectric layered structure with omnidirectional photonic band gap. Applied Physics Letters, 2000. 77(3490).Google Scholar
9 Qi, M. et al. , A Three-Dimensional Optical Photonic Crystal with Designed Point Defects. Nature, 2004. 429.CrossRefGoogle ScholarPubMed
10 Johnson, S.G. and Joannopoulos, J.D. Photonic Crystals: The Road from Theory to Practice. 2002: Klurwer Academic.Google Scholar