Hostname: page-component-78c5997874-g7gxr Total loading time: 0 Render date: 2024-11-17T16:26:41.409Z Has data issue: false hasContentIssue false

3.3μm Pyrometry In Single Sided Rta From 400–700°C Using In-Situ Measurement Of Reflection And Transmission

Published online by Cambridge University Press:  10 February 2011

D. L. Marcy
Affiliation:
Department of Electrical Engineering, Princeton University, Princeton, NJ
S. Chial
Affiliation:
Current address : Department of Electrical Engineering, Georgia Institute of Technology, Atlanta, Ga
M. Beneš
Affiliation:
Department of Electrical Engineering, Princeton University, Princeton, NJ
J. C. Sturm
Affiliation:
Department of Electrical Engineering, Princeton University, Princeton, NJ
Get access

Abstract

Pyrometry of silicon wafers under 700°C at wavelengths over 1μm is difficult because lightly doped wafers become partially transparent. In this work, a modified commercial RTCVD reactor with 8” wafer capability was used to study the temperature measurement of Si wafers over the range of 400–700°C using top and bottom pyrometric detectors. We present initial results on measurements of both reflection and transmission in-silu to determine emissivity at 3.3μm. For heavily doped wafers emissivity was independent of temperature and the measured temperature by pyrometry agreed well with that measured by thermocouple for 400–700°C. For lightly doped wafers, emissivity was temperature dependent due to the increased transparency of the wafer at low temperatures. Using fixed emissivity, the measured temperature severely underestimates the actual temperature below 550°C. By calculating emissivity from the measured reflection and transmission, accurate temperature measurement was achieved from 400–700°C without any a priori knowledge of the wafer.

Type
Research Article
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Schietinger, C., Adams, B., and Yarling, C., “Ripple Technique; A Novel Non-Contact Wafer Emissivity and Temperature Method for RTP”, Materials Research Society, Spring 1991 Meeting.Google Scholar
2. Sato, T., “Spectral Emissivity of Silicon”, Japan J. of Appl. Phys. v 6, no. 3, (March, 1967), pp. 339347.Google Scholar