Hostname: page-component-8448b6f56d-c47g7 Total loading time: 0 Render date: 2024-04-19T21:39:12.062Z Has data issue: false hasContentIssue false
  • English
  • Français

2D and 3D X-Ray Structural Microscopy Using Submicron-Resolution Laue Microdiffraction

Published online by Cambridge University Press:  01 February 2011

John D. Budai ,
Wenge Yang ,
Bennett C. Larson ,
Jonathan Z. Tischler ,
Wenjun Liu  and
Gene E. Ice
John D. Budai
Affiliation:
Condensed Matter Sciences Division, Oak Ridge National Laboratory
Wenge Yang
Affiliation:
Condensed Matter Sciences Division, Oak Ridge National Laboratory
Bennett C. Larson
Affiliation:
Condensed Matter Sciences Division, Oak Ridge National Laboratory
Jonathan Z. Tischler
Affiliation:
Condensed Matter Sciences Division, Oak Ridge National Laboratory
Wenjun Liu
Affiliation:
Metals & Ceramics Division, Oak Ridge National Laboratory Oak Ridge, TN 37831–6030, U.S.A.
Gene E. Ice
Affiliation:
Metals & Ceramics Division, Oak Ridge National Laboratory Oak Ridge, TN 37831–6030, U.S.A.
Get access

Abstract

We have developed a scanning, polychromatic x-ray microscopy technique with submicron spatial resolution at the Advanced Photon Source. In this technique, white undulator radiation is focused to submicron diameter using elliptical mirrors. Laue diffraction patterns scattered from the sample are collected with an area detector and then analyzed to obtain the local crystal structure, lattice orientation, and strain tensor. These new microdiffraction capabilities have enabled both 2D and 3D structural studies of materials on mesoscopic length-scales of tenths-to-hundreds of microns. For thin samples such as deposited films, 2D structural maps are obtained by step-scanning the area of interest. For example, 2D x-ray microscopy has been applied in studies of the epitaxial growth of oxide films. For bulk samples, a 3D differential-aperture x-ray microscopy technique has been developed that yields the full diffraction information from each submicron volume element. The capabilities of 3D x-ray microscopy are demonstrated here with measurements of grain orientations and grain boundary motion in polycrystalline aluminum during 3D thermal grain growth. X-ray microscopy provides the needed, direct link between the experimentally measured 3D microstructural evolution and the results of theory and modeling of materials processes on mesoscopic length scales.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 840: Symposium Q – Neutron and X-Ray Scattering as Probes of Multiscale Phenomena , 2004 , Q7.1
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Larson, B.C. and Lengeler, B., editors, Mat. Res. Soc. Bull. 29, 152 (2004).Google Scholar
2. Fu, X., Poulsen, H.F., Schmidt, S., Nielsen, S.F., Lauridsen, E.M., and Juul Jensen, D., Scr. Mat. 49, 1093 (2003).Google Scholar
3. Riekel, C., Rep. Prog. Phys. 63, 233 (2000).Google Scholar
4. Ice, G.E. and Larson, B.C., Adv. Eng. Mater. 2, 643 (2000).Google Scholar
5. Tamura, N., Celestre, R.S., MacDowell, A.A., Padmore, H.A., Spolenak, R., Valek, B.C., Meier Chang, N., Manceau, A., and Patel, J.R., Rev. Sci. Instrum. 73, 1369 (2002).Google Scholar
6. Larson, B.C., Yang, W., Ice, G.E., Budai, J.D. and Tischler, J.Z., Nature 415, 887 (2002).Google Scholar
7. Budai, J.D., Yang, W., Tamura, N., Chung, J.S., Tischler, J.Z., Larson, B.C., Ice, G.E., Park, C. and Norton, D.P., Nature Mat. 2, 487 (2003).Google Scholar
8. Yang, W., Larson, B.C., Tischler, J.Z., Ice, G.E., Budai, J.D., and Liu, W., Micron 35, 431 (2004).Google Scholar
9. Chung, J.-S. and Ice, G.E., J. Appl. Phys. 86, 5249 (1999).Google Scholar
10. Wu, C.T., Adams, B.L., Bauer, C.L., Casasent, D., Morawiec, A., Ozdemir, S. and Talukder, A., Ultramicroscopy 93, 99 (2002).Google Scholar
11. Barabash, R.I., Ice, G.E., Tamura, N., Valek, B.C., Bravman, J.C., Spolenak, R., and Patel, J.R., J. Appl. Phys. 93, 5701 (2003).Google Scholar
12. Yang, W., Larson, B.C., Pharr, G.M., Ice, G.E., Budai, J.D., Tischler, J.Z. and Liu, W., Jour. Mater. Res. 19, 66 (2004).Google Scholar
13. Norton, D.P., Goyal, A., Budai, J.D., Christen, D., Kroeger, D., Specht, E.D., He, Q., Saffian, B., Paranthaman, M., Klabunde, C., Lee, D., Sales, B., and List, F., Science 274, 755 (1996).Google Scholar
14. Demirel, M.C., Kuprat, A.P., George, D.C. and Rollett, A.D., Phys. Rev. Lett. 90, (2003), Art. 016106.Google Scholar
15. Radhakrishnan, B. and Zacharia, T., Modelling Simul. Mater. Sci. Eng. 10, 227 (2002).Google Scholar
16. Janssens, K.G.F, Modelling Simul. Mater. Sci. Eng. 11, 157 (2003).Google Scholar
17. Budai, J.D., Yang, W., Larson, B.C., Tischler, J.Z., Liu, W., Weiland, H., and Ice, G.E., Materials Science Forum 467–470, 1373 (2004).Google Scholar
18. Schmidt, S., Nielsen, S. F., Gundlach, C., Margulies, L., Huang, X., and Juul Jensen, D., Science 305, 229 (2004).Google Scholar