Article contents
Additive Manufacturing of Ni-Mn-Cu-Ga: Influence of Sintering Temperature on Magnetocaloric Effect and Microstructure
Published online by Cambridge University Press: 05 August 2019
Abstract
An abstract is not available for this content so a preview has been provided. As you have access to this content, a full PDF is available via the ‘Save PDF’ action button.
- Type
- Advanced Characterization of Components Fabricated by Additive Manufacturing
- Information
- Copyright
- Copyright © Microscopy Society of America 2019
References
[6]The authors acknowledge facilities at the Univ. of Pittsburgh: PINSE NFCF, MMCL, MCL, ANSYS AMRL. E.S. was supported by the DoD through the NDSEG program. K.K. was supported by PPG and SSOE. Project MAT2014-56116-C4-1-3-4-R from MINECO, Spain is acknowledged. A Perez, J Feuchtwanger, A Mostafaei, A Acierno, P Lázpita, and J Toman are acknowledged for their assistance. Research funding was provided by the Mascaro Center for Sustainable Innovation.Google Scholar
You have
Access
- 7
- Cited by