Hostname: page-component-8448b6f56d-c4f8m Total loading time: 0 Render date: 2024-04-18T22:22:19.376Z Has data issue: false hasContentIssue false
  • English
  • Français

Microwave heating of ceramics and its application to joining

Published online by Cambridge University Press:  31 January 2011

H. Fukushima ,
T. Yamanaka  and
M. Matsui
H. Fukushima
Affiliation:
Toyota Central R & D Labs Inc., Aichi, 480-11, Japan
T. Yamanaka
Affiliation:
Toyota Central R & D Labs Inc., Aichi, 480-11, Japan
M. Matsui
Affiliation:
Toyota Central R & D Labs Inc., Aichi, 480-11, Japan
Get access

Abstract

A new butt joining method for ceramics by microwave heating was developed. Ceramics were heated in a rectangular cavity, and a klystron of maximum 3 kW at 6 GHz was used as the power amplifier. The heating system can control an iris, a plunger, and the microwave power to maintain the power efficiency up to 90% and the accuracy within ±10°C at 1800 °C. This system was applied to alumina-alumina direct joining. The average strength of alumina rods (92% purity) joined for 3 min was 420 MPa, which was equal to the original strength. The joined boundary line at the interface was not observed, and there was little difference in microstructure between before and after joining. This suggests that sintering aids in the grain boundary phase were preferentially heated and melted, resulting in the sound joining of ceramics. Next, silicon nitride ceramics containing yttrium were indirectly joined with an intermediate, which was a sintered ceramic sheet having lower purity and larger dielectric loss factor than the base material. The microwave energy was concentrated on the ceramic sheet, so that only the joining area was locally heated. The strength of the joined rods was in excess of 70% of the base material, but a deficient layer of yttrium occurred in the area of the joined boundary.

Type
Articles
Information
Journal of Materials Research , Volume 5 , Issue 2 , February 1990 , pp. 397 - 405
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1Johnson, D. L. and Brodwin, M. E., U. S. Army Research Office, Grant No. DAAG 29–80-K-0031, 1984.Google Scholar
2Meek, T.T. and Blake, R. D., Mater, J.. Sci. Lett. 5, 270 (1986).CrossRefGoogle Scholar
3Palaith, D., Silberglitt, R., and Libelo, E., Ceram. Mater. Conpor.Engines, 459 (1986).Google Scholar
4Okada, F., Tashiro, S., and Suzuki, M., Adv. Ceram. 201 (1985).Google Scholar
5Fukushima, H., Yamanaka, T., Azuma, H., and Matsui, M., J. Japan Soc. of Prec. Eng. 54, 305 (1988).CrossRefGoogle Scholar
6Fukushima, H., Yamanaka, T., and Matsui, M., J. Japan Soc. of Prec. Eng. 53, 743 (1987).CrossRefGoogle Scholar
7 Diagrams for Ceramics, Am. Ceram. Soc, 185 (1964).Google Scholar
8Kohno, A., Hioki, S., Yamada, T., and Nakae, N., Brit. Ceram. Proc. 37, 125 (1986).Google Scholar