Hostname: page-component-8448b6f56d-jr42d Total loading time: 0 Render date: 2024-04-25T05:18:23.963Z Has data issue: false hasContentIssue false
  • English
  • Français

Erratum: “Representative strain of indentation analysis” [J. Mater. Res. 20, 2225 (2005)] and “Limit analysis-based approach to determine the material plastic properties with conical indentation” [J. Mater. Res. 21, 947 (2006)]

Published online by Cambridge University Press:  03 March 2011

Nagahisa Ogasawara ,
Norimasa Chiba  and
Xi Chen
Nagahisa Ogasawara
Affiliation:
Department of Mechanical Engineering, National Defense Academy, Hashirimizu, Yokosuka 239, Japan
Norimasa Chiba
Affiliation:
Department of Mechanical Engineering, National Defense Academy, Hashirimizu, Yokosuka 239, Japan
Xi Chen*
Affiliation:
Department of Civil Engineering and Engineering Mechanics, Columbia University, New York, New York 10027
*
a) Address all correspondence to this author. e-mail: xichen@civil.columbia.edu

Extract

Core share and HTML view are not available for this content. However, as you have access to this content, a full PDF is available via the ‘Save PDF’ action button.

We like to take this opportunity to rectify an error in the schematic drawing in two of our recently published research articles. A typographical error of a number appeared in Fig. 5 of J. Mater. Res. 20, 2225 (2005), p. 2229 and in Fig. 2 of J. Mater. Res. 21, 947 (2006), p. 948: these two figures are the same schematic drawing. In both figures, the number “1” on the slopes should be changed to “2.” The correct figure is given as Fig. 1 in this erratum.

Type
Erratum
Information
Journal of Materials Research , Volume 21 , Issue 10 , October 2006 , pp. 2699 - 2700
Copyright
Copyright © Materials Research Society 2006

References

REFERENCES

1.Ogasawara, N., Chiba, N., Chen, X.: Representative strain of indentation analysis. J. Mater. Res. 20, 2225 (2005).CrossRefGoogle Scholar
2.Ogasawara, N., Chiba, N., Chen, X.: Limit analysis-based approach to determine the material plastic properties with conical indentation. J. Mater. Res. 21, 947 (2006).CrossRefGoogle Scholar
3.Cao, Y., Huber, N.: Further investigation on the definition of the representative strain in conical indentation. J. Mater. Res. 21, 1810 (2006).CrossRefGoogle Scholar
4.Ogasawara, N., Chiba, N., Zhao, M., Chen, X.Comments on “Further investigation on the definition of the representative strain in conical indentation” by Y. Cao and N. Huber [J. Mater. Res. 21, 1810, (2006)], J. Mater. Res. (2006) (submitted).Google Scholar
5.Ogasawara, N., Chiba, N., Zhao, M., Chen, X.Determine material plastic and elastic properties with optimized representative strain-based indentation technique. J. Mech. Mater. Struct. (2006) (submitted).Google Scholar