Hostname: page-component-788cddb947-rnj55 Total loading time: 0 Render date: 2024-10-18T23:06:19.019Z Has data issue: false hasContentIssue false
  • English
  • Français

Determination of Rolling Contact Stress Distribution by X-ray Diffraction

Published online by Cambridge University Press:  06 March 2019

David L. Milan
David L. Milan*
Affiliation:
Material Science Research, The Timken Company Canton, Ohio
Get access

Abstract

An investigation was conducted of the potential for detection of the contact stress distribution in tapered roller bearing components made of carburized steel. Various raceway stress distributions were created by control of the profile and alignment of the rolling surfaces. Determination of residual stress in the rolling direction and peak breadth were made using a multiple tilt sin2 ψ technique. The measurements were made at the surface and at depths below the surface. It was found that the distribution of residual stress and peak breadth perpendicular to the rolling direction in the layers below the surface of the inner race correlated highly with the imposed contact stress distribution. The correlation was less in the case of the outer race. The residual stress distribution measured on the surface of the inner race was observed to be inversely proportional to the contact stress distribution.

Type
Research Article
Information
Advances in X-Ray Analysis , Volume 33: Thirty-Eighth Annual Conference on Applications of X-ray Analysis, July 31 - August 4, 1989 , 1989 , pp. 341 - 352
Copyright
Copyright © International Centre for Diffraction Data 1989

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Swahn, H., Becker, P. C., and Vingsboro, O.: Metal. Trans, A, 7A (1976) 1099–1110.Google Scholar
2. Swirlein, O. and Schlicht, H.: Rolling contact Fatigue Testing of Bearing steels, ASTM 771, Hoo, J. J. C., E d., Amer. Soc. for Teszing and Materials, 1982, pp 358-379.Google Scholar
3. Bush, J. J., Grube, W. L., and Robinson, G. A.: Trans. ASM 54, (1961) 390-412.Google Scholar
4. Voskamp, A. P., R. Osterlund, Becker, P. C., and Vingsboro, O.: Metals Technology 7, (1980) 14-21.Google Scholar
5. Muro, H. and Tsushima, N.: Wear 15, (1970) 309-330.Google Scholar
6. Gentile, A. J., Jordan, E. F., and Martin, A. D.: Trans. AIME 223, (1955) 1085-1093.Google Scholar
7. Muro, H., Tsushima, N., and Nunome, K.: Wear 25, (1973) 345-356,Google Scholar
8. Schlicht, H., Schreiber, E., and Zwirlein, O., Ball and Roller Bearing Engineering, 1987-1, FAG, 14-22.Google Scholar
9. Marion, R. H. and Cohen, J. B.: Advances in X-Ray Analysis 18, (1975) 466-501.Google Scholar