The application of random-phase plates in laser beams to improve the uniformity of target ablation is investigated by combining the simultaneous X-ray and particle emission measurements of ablation characteristics. It is shown that if some hot spots with dimensions of a few µm exist on target they persist at least during the initial stages of the laser interaction process, producing a local maximum in the ablation pressure. Lateral energy transport, inferred from the neutral particle measurements, has little influence on absorbed energy redistribution (only 1% of the energy is transported from the laser focal spot to an outer region of 2 mm size).

The aluminium side of two-layer Al-Plastic targets were irradiated with a long pulse (∼ 2.4 ns FWHM) 1.06-μm laser light at intensities up to 7 × 1013 W/cm2. The time history of the thermal emission of the confined rear surface of the aluminum was measured. Visible emission only occurs for a short time after the arrival of the laser-generated shock waves. Over the range of the measurements, the duration and the intensity of the emission reduce with increasing laser intensity. The experimental results are in good agreement with the results of a simple phenomenological model that assumes a linear temperature and density profile on the shock front. The values of shock velocity and maximum temperature and density that were used in the model were found using the hydrodynamic simulation code MEDUSA. From the model the shock width was measured for different conditions by matching the emission of the experiment and model. It is found that the time history of the emission is strongly sensitive to the ionization potential of the plastic that is assumed to change with density from ∼ 4 eV at zero pressure to zero at high densities. The technique provides a way to measure the pressure metallization of large band gap insulators.

We have studied the interaction of soft X-ray thermal radiation with foam-layered metal targets. The X-radiation was produced by focusing a high energy laser inside a small size hohlraum. An increment in shock pressure was observed with the foam layer as compared to bare metal targets.

We present some experimental results which demonstrate the presence of electric inhibition in the propagation of relativistic electrons generated by intense laser pulses, depending on target conductivity. The use of transparent targets and shadowgraphic techniques has made it possible to evidence electron jets moving at the speed of light, an indication of the presence of self-generated strong magnetic fields.

The first experimental study of the propagation of electrons created by an intense laser in shock-compressed matter has been performed with the VULCAN laser facility at the Rutherford Appleton Laboratory, to investigate one of the fundamental phases of the fast ignitor concept for inertial confinement fusion. Plastic plane targets were irradiated on one side with two pulsed laser beams, each with I ≈ 1014 W/cm2, t ≈ 2 ns, E ≈ 80 J per pulse, to generate a planar shock wave; on the opposite side of the target, a chirped pulse amplification (CPA) laser beam (I ≈ 1016 W/cm2, t ≈ 3 ps, E ≈ 10 J) was focused to generate the fast electrons. The results show an increase of hot electron penetration in compressed matter with respect to an ordinary one. Experimental results have been analyzed with computer simulations.