Enlist E3TM soybean cultivars permit over-the-top application of labeled glyphosate, glufosinate, and 2,4-D choline products. Increased Enlist E3TM trait adoption and use of 2,4-D choline postemergence across U.S. soybean production systems raise concerns regarding potential for 2,4-D off-target movement (OTM). A large-scale drift experiment was established near Sun Prairie, WI, and Arlington, WI, in 2019 and 2020, respectively. A 2,4-D-resistant soybean cultivar was planted in the center of the field (∼3 ha), while the surrounding area was planted with a 2,4-D-susceptible cultivar. An application of 785 ae ha−1 2,4-D choline plus 834 g ae ha−1 glyphosate was completed within the center block at R2 and V6 growth stages on August 1, 2019, and July 3, 2020, respectively. Filter papers were placed in-swath and outside of the treated area in one upwind transect and three downwind transects to estimate particle deposition. Low-volume air samplers ran for the 0.5-h to 48-h period following application to estimate 2,4-D air concentration. Injury to 2,4-D-susceptible soybean was assessed 21 d after treatment (0% to 100% injury). The 2,4-D deposition in-swath was 9,966 and 5,727 ng cm−2 in 2019 and 2020, respectively. Three-parameter log-logistic models estimated the distance to 90% reduction in 2,4-D deposition (D90) to be 0.63 m and 0.90 m in 2019 and 2020, respectively. In 2020, the 2,4-D air concentration detected was lower for the upwind (0.395 ng m−3) than the downwind direction (1.34 ng m−3), although both were lower than the amount detected in-swath (4.01 ng m−3). No soybean injury was observed in the downwind or upwind directions. Our results suggest that 2,4-D choline applications following label recommendations pose little risk to 2,4-D-susceptible soybean cultivars; however, further work is needed to understand 2,4-D choline OTM under different environmental conditions and the presence of other susceptible crops.

Use of synthetic auxin herbicides has increased across the midwestern United States after adoption of synthetic auxin-resistant soybean traits, in addition to extensive use of these herbicides in corn. Off-target movement of synthetic auxin herbicides such as dicamba can lead to severe injury to sensitive plants nearby. Previous research has documented effects of glyphosate on spray-solution pH and volatility of several dicamba formulations, but our understanding of the relationships between glyphosate and dicamba formulations commonly used in corn and for 2,4-D remains limited. The objectives of this research were to (1) investigate the roles of synthetic auxin herbicide formulation, glyphosate, and spray additives on spray solution pH; (2) assess the impact of synthetic auxin herbicide rate on solution pH; and (3) assess the influence of glyphosate and application time of year on dicamba and 2,4-D volatility using soybean as bioindicators in low-tunnel field volatility experiments. Addition of glyphosate to a synthetic auxin herbicide decreased solution pH below 5.0 for four of the seven herbicides tested (range of initial pH of water source, 7.45–7.70). Solution pH of most treatments was lower at a higher application rate (4× the labeled POST rate) than the 1× rate. Among all treatment factors, inclusion of glyphosate was the most important affecting spray solution pH; however, the addition of glyphosate did not influence area under the injury over distance stairs (P = 0.366) in low-tunnel field volatility experiments. Greater soybean injury in field experiments was associated with high air temperatures (maximum, >29 C) and low wind speeds (mean, 0.3–1.5 m s−1) during the 48 h after treatment application. The two dicamba formulations (diglycolamine with VaporGrip® and sodium salts) resulted in similar levels of soybean injury for applications that occurred later in the growing season. Greater soybean injury was observed after dicamba than after 2,4-D treatments.