We present laboratory measurement and theoretical analysis of silicon K-shell lines in plasmas produced by Shenguang II laser facility, and discuss the application of line ratios to diagnose the electron density and temperature of laser plasmas. Two types of shots were carried out to interpret silicon plasma spectra under two conditions, and the spectra from 6.6 Å to 6.85 Å were measured. The radiative-collisional code based on the flexible atomic code (RCF) is used to identify the lines, and it also well simulates the experimental spectra. Satellite lines, which are populated by dielectron capture and large radiative decay rate, influence the spectrum profile significantly. Because of the blending of lines, the traditional $G$ value and $R$ value are not applicable in diagnosing electron temperature and density of plasma. We take the contribution of satellite lines into the calculation of line ratios of He-$\unicode[STIX]{x1D6FC}$ lines, and discuss their relations with the electron temperature and density.

A novel radio frequency identification tag antenna is composed of a resonant open-slot exciter and a dipole-type ground radiator. For a conjugate match to the Alien Higgs-4 chip impedance of 8−j149 Ω at 925 MHz, a quarter wavelength open-slot resonator embedded at the center of the dipole-type ground plane (130 × 18 mm2) was investigated and fabricated. Simple size adjustments and various loaded inductor of the open-slot resonator allow for easy control of the tag antenna resistance and inductive reactance, from which the chip impedance requirement can be easily obtained. The read range of the prototype antenna attached on a foam in the free space can reach more than 9 m, which has been tested for a radio frequency identification reader with 4.0-W of effective isotropic radiated power. Measurement data are in good agreement with simulation results.

Consumers' psychological perceptions of a product are significantly influenced by its appearance aesthetics, and thus product form plays an essential role in determining the commercial success of a product. The evolution of a product's form during the design process is typically governed by the designer's individual preferences and creative instincts. As a consequence, there is a risk that the product form may fail to satisfy the consumers' expectations or may induce an unanticipated consumer response. This study commences developing an integrated design approach based on the numerical definition of product form. A series of evaluation trials are then performed to establish the correlation between the product form features and the consumers' perceptions of the product image. The results of the evaluation trials are used to construct three different types of mathematical model (a multiple regression analysis model, a backpropagation neural network model, and a multiple regression analysis with a backpropagation neural network model) to predict the likely consumer response to any arbitrary product form. The feasibility of an integrated design approach is demonstrated using a three-dimensional knife form. Although this study takes an example for illustration and verification purposes, the methodology proposed in the present study is equally applicable to any form of consumer product.

This study aims to investigate barriers to the adoption of information and communication technology (ICT) for teachers of Chinese as a foreign language (CFL) in US universities. Although the development of ICT for teaching is growing, few published studies address ICT specifically regarding CFL teaching. Therefore, this study has reviewed the existing ICT literature's treatment of important ICT-related matters, including barrier factors, and has examined them in the context of CFL teaching. The current study features a mixed method, consisting of a survey and semi-structured interviews. Of the 47 CFL teachers who participated in the study, five volunteered for in-depth interviews. According to our findings, the most critical barriers to these CFL teachers’ adoption of ICT were insufficient support and insufficient time for developing technology-driven pedagogy and activities. These issues are reflected in CFL teachers’ unique subject expertise and workloads in existing universities’ curricula and approaches to instruction. In addition, age influences CFL teachers’ confidence in their use of ICT for the preparation of subject material and for teaching, whereas gender influences their willingness to spend time working on ICT.

Impaired regulation of blood glucose levels in diabetes mellitus (DM) patients and the associated elevation of blood glucose levels are known to increase the risk of diabetic cardiomyopathy (DC). In the present study, a probiotic bacterium, Lactobacillus reuteri GMN-32, was evaluated for its potential to reduce blood glucose levels and to provide protection against DC risks in streptozotocin (STZ)-induced DM rats. The blood glucose levels of the STZ-induced DM rats when treated with L. reuteri GMN-32 decreased from 4480 to 3620 mg/l (with 107 colony-forming units (cfu)/d) and 3040 mg/l (with 109 cfu/d). Probiotic treatment also reduced the changes in the heart caused by the effects of DM. Furthermore, the Fas/Fas-associated protein with death domain pathway-induced caspase 8-mediated apoptosis that was observed in the cardiomyocytes of the STZ-induced DM rats was also found to be controlled in the probiotic-treated rats. The results highlight that L. reuteri GMN-32 treatment reduces blood glucose levels, inhibits caspase 8-mediated apoptosis and promotes cardiac function in DM rats as observed from their ejection fraction and fractional shortening values. In conclusion, the administration of L. reuteri GMN-32 probiotics can regulate blood glucose levels, protect cardiomyocytes and prevent DC in DM rats.

The ability of silver (Ag)-containing borate bioactive glass (BG) coatings to improve the biocompatibility and antibacterial properties of titanium (Ti) implants was investigated in vitro and in vivo in a rabbit tibial fracture model. Dense coatings of borate BG (thickness ≈ 20 μm) containing 0, 0.75, and 1.0 wt% Ag2O were prepared by depositing a layer of particles on Ti plates, followed by sintering at 900 °C. The as-prepared coatings had an adhesive strength of 10 ± 1 MPa, and when immersed in an aqueous phosphate (K2HPO4) solution, the coatings converted to hydroxyapatite, releasing Ag+ ions continuously for over 4 wk. After implantation of BG-coated Ti constructs in a rabbit tibial fracture model and of methicillin-resistant Staphylococcus aureus-induced osteomyelitis, the BG coating doped with 1.0 wt% Ag2O was most effective for the simultaneous eradication of the infection and fracture fixation. Implants coated with Ag-containing BG coatings could provide an approach for reducing implant-related bone infection.

We report herein the crystal growth of ZnO nanoparticles by the foam fractionation method. In this study, the vertical column height of the foam was fixed and the velocity of the sparging air was varied, and the effect of foam flow rate on the synthesis of ZnO was investigated. The obtained ZnO consisted of aggregated platelets and had differing ultraviolet absorbances. The as-synthesized ZnO was hydrophobic because of the interaction between the anionic head groups of sodium dodecyl sulfate (SDS) and the ZnO under the precipitation conditions. The long chain of the SDS molecule was the cause of hydrophobicity. The contact angle of water was in the range of 95–105° for the obtained ZnO/SDS surface. The photocatalytic degradation efficiency of the as-synthesized (ZnO/SDS) and the calcined ZnO was investigated for methylene blue, and the calcined ZnO retained its activity even after three recycles.

Circulating levels of leptin and adiponectin are closely associated with obesity. However, it is not known whether there are common shared genes or environment exerting influences on the levels of leptin, adiponectin, and BMI. We aimed to assess the relative contribution of genes and environment to adiponectin, leptin, and BMI individually as well as simultaneously to the three measures. Our subjects included a total of 228 twin/sibling pairs aged 12 to 18 (130 monozygotic twins, 68 dizygotic twins and 30 sibling pairs) were recruited from the middle schools. Multivariate analyses were applied to twin/sibling data using structural equation modeling. The results showed that intraclass correlations for adiponectin, leptin and BMI were higher in the MZ twins than those in the DZ/SP group. The relative contribution of genes to adiponectin (39%) was comparable to those of shared environment (40%). In contrast, leptin and BMI were influenced mostly by genes (74% and 89%, respectively). The multivariate genetic analyses showed that a latent factor underlying the three measures was identified, with BMI being equivalent to this latent factor. The BMI-dependent genetic factor explains only 15% and 34% of variation of adiponectin and leptin, respectively. These data indicate a differential contribution of genetic factors for the variation of adiponectin, leptin and BMI. More importantly, only a small portion of the genetic influences on adiponectin and leptin was attributed to BMI. Our findings provided more insight into the complex regulation of adiponectin and leptin in obesity.

During diabetes, structural and functional changes in the alimentary tract are known to take place resulting in an increased absorption of intestinal glucose and alterations in the activities of brush-border disaccharidases. To elucidate the effect of administrating polysaccharide from Gynura divaricata (PGD) on disaccharidase activities, the specific activities of intestinal disaccharidases, namely sucrase, maltase and lactase, were measured in streptozotocin-induced diabetic rats. Normal control and diabetic rats were treated by oral administration with PGD. Specific activities of intestinal disaccharidases were increased significantly during diabetes, and amelioration of the activities of sucrase and maltase during diabetes was clearly visible by the treatment with PGD. However, the increased activity of lactase during diabetes mellitus was remarkably alleviated by the administration of PGD only in the duodenum. Meanwhile, oral sucrose tolerance tests demonstrated that PGD alleviated the hyperglycaemia during diabetes mellitus, resulting from the amelioration in the activities of intestinal disaccharidases. The present investigation suggests that PGD exerted an anti-diabetic effect partly via inhibiting the increased intestinal disaccharidase activities of diabetic rats. This beneficial influence of administration of PGD on intestinal disaccharidases clearly indicates their helpful role in the management of diabetes.

The Critically Endangered Chinese crested tern Sterna bernsteini is a poorly known species. From June 2003 to August 2007 we therefore surveyed the Zhejiang and Shandong coasts of eastern China for breeding colonies and to document any threats. Our results indicated that (1) the colonies at Matzu and Jiushan are the only two in the species' potential breeding range, (2) the total population is no more than 50, (3) numbers in the two extant breeding colonies fluctuate annually, and (4) threats to the breeding populations include habitat degradation, egg poaching, disturbance, overfishing and typhoons. Egg poaching is the greatest threat to the Chinese crested tern population and other breeding seabird populations along the coast of China. We make recommendations for the conservation of this species.

Intergeneric transfer of plasmid vectors pSET152 and pHL212 from donor Escherichia coli ET12567/pUZ8002 and S17-1 to Streptomyces cinnamonensis was demonstrated and optimized. Assisted by this conjugation system, nsdA gene disruption was achieved through PCR-targeted gene replacement. One AprRKanS exconjugant BIB309 was then isolated and confirmed to be the nsdA null mutant. Compared with the starting strain, monensin production by the nsdA− mutant BIB309 increased 270% in vitro.

In this work, we report on the growth of ultraviolet (UV) AlGaN/GaN multiple quantum wells (MQWs) structure using atomic layer deposition (ALD) technique. The AlGaN/GaN MQW sample grown on the sapphire substrate consisted of three GaN QWs and four AlGaN barriers comprised AlN/GaN superlattices (SLs). The root-mean-square value of the surface morphology was only 0.35 nm observed from the atomic force microscope image and no crack was found on the surface. Both of the high resolution X-ray diffraction curves and transmission electron microscope images showed sharp interfaces between SLs layers and QWs with good periodicity. These results demonstrate that the ALD could be a very useful technique for controlling the crystalline quality and thickness of the III-nitride epilayer.

Solder pots used in wave soldering are usually made using different kinds of steel. Dissolution and interfacial reactions of the Fe substrate in molten Sn-Pb and Sn-Cu solders are investigated in this study. FeSn2 phase is formed in the Sn-0.7wt%Cu/Fe couples reacted at 250, 400, and 500 °C, as well as in the Sn-37wt%Pb/Fe couples reacted at 250 and 400 °C. The activation energies of formation are 123 and 121 kJ/mol in the Sn-Cu/Fe and Sn-Pb/Fe couples, respectively. FeSn phase is the reaction product in the Sn-37wt%Pb/Fe couples reacted 500 °C. The dissolution rates of Fe in the Sn-0.7wt%Cu melt are much higher than those in-the Sn-37wt%Pb melt. The FeSn2 phase layer in the Sn-Cu/Fe couple is not as dense as that in the Sn-Pb/Fe couple and accounts for the very different dissolution rates. Detachment of the reaction FeSn2 phase into the solder matrix is observed in the Sn-Cu/Fe couples, and is a potential contaminant source in wave soldering.

In this work, the charge-trapping distributions of polysilicon-oxide-nitride-oxide-silicon (SONOS) structure are studied. The trapping energy level of SiNx films with different composition ratio deposited by low-pressure chemical vapor deposition (LPCVD) were first characterized by photoluminescence (PL) measurement. Moreover, using F-N/CHE program and charge pumping techniques, the vertical location and the lateral distribution of programmed charges are investigated in the nitride films with different composition ratio. The study offers strong evidence that the density of charge-trapping levels in the Si-rich nitride is higher than the standard nitride. A simple qualitative model and calculation explains that the trapping level distributions in the SiNx films are shallower by increasing relative Si-content. Furthermore, we have observed the nitride trap vertical location was changed by adjusted Si/N composition ratio. And the lateral distribution of hot electron programmed charges in the modified nitride is broader than that in the standard nitride because it offered more charge-trapping sites and shallower charge-trapping levels. In summary, the study can help researchers to understand the nitride charge-trapping mechanism and the analysis of optical/electrical characteristics.