Hostname: page-component-5c6d5d7d68-thh2z Total loading time: 0 Render date: 2024-08-18T12:55:37.312Z Has data issue: false hasContentIssue false
  • English
  • Français

The Relation Between Microstructure and Electronic Properties of Magnetron Sputtered a-Si1−x,Cx:H

Published online by Cambridge University Press:  01 January 1993

S.Y. Yang ,
N. Maley  and
J.R. Abelson
S.Y. Yang
Affiliation:
Coordinated Science Laboratory and the Materials Science and Engineering Department, University of Illinois, Urbana, IL 61801
N. Maley
Affiliation:
Solarex Corp., Thin Film Division, Newtown, PA 16802
J.R. Abelson
Affiliation:
Coordinated Science Laboratory and the Materials Science and Engineering Department, University of Illinois, Urbana, IL 61801
Get access

Abstract

We have grown a-Si1-x,Cx:H films by reactive magnetron sputtering, varying the H2 partial pressure from 0 to 6 mTorr and maintaining the substrate temperature at 275°C and argon and methane partial pressures at 1.70 and 0.10 mTorr, respectively.

We investigate the correlation between electronic properties and the fraction of H bonded in "microstructure," defined by the ratio of SiHx stretching mode absorptions in IR and the low temperature H2release in thermal evolution. Our results on sputtered films disprove the monotonic decrease in carrier transport with increasing microstructure fraction which is commonly observed for a-Si1-xCx:H grown by glow discharge of SiH4 and CH4. We find that the electronic properties and microstructure depend on film composition and growth technique, and that the electronic properties are not uniquely determined by the microstructure of hydrogen bonding.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 297: Symposium A – Amorphous Silicon Technology - 1993 , 1993 , 675
Copyright
Copyright © Materials Research Society 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

(1) Kruangam, D., in Amorphous & Microcrystalline Semiconductor Devices:Optoelectronic Devices, edited by Kanicki, Jerzy (Artech House, Boston. London, 1991), p. 195.Google Scholar
(2) Mahan, A. H., Raboisson, P., Williamson, D. L. and Tsu, R., Solar Cells. 297, 117 (1987)Google Scholar
(3) Baker, S. H., Spear, W. E. and Gibson, R. A. G., Phil. Mag., B, 62, 213 (1990)Google Scholar
(4) Lu, H. Y. and Petrich, M. A., J. Appl. Phys. 71, 1693 (1992)Google Scholar
(5) Bhattacharya, E. and Mahan, A. H., Appl. Phys. Lett. 52, 1587 (1988)Google Scholar
(6) Beyer, W., Wagner, G. and Finger, G., J. Non-Crystalline Solids, 77–78, 857 (1985)Google Scholar
(7) Mahan, A. H., Raboisson, P. and Tsu, R., Appl. Phys. Lett. 50, 335 (1987)Google Scholar
(8) Wieder, H., Cardona, M., and Guarnieri, C. R., Phys. Stat. Sol. (B) 92, 99 (1979)Google Scholar
(9) Jousse, D., Bustarret, E., and Boulitrop, F., Solid State Communication, 55, 435 (1985)Google Scholar
(10) Moustakas, T. D., in Semiconductors and Semimetals. Vol. 297, part A, edited by Pankove, J., (Academic Press, 1984), p. 55.Google Scholar
(11) Yang, S.-Y. and Abelson, J. R., to be published in J. Vac. Sci. Tech., August 1993.Google Scholar
(12) Mahan, A. H., Williamson, D. L., Nelson, B. P., and Crandall, R. S., Phys. Rev. B 40, 12024 (1989)Google Scholar