Hostname: page-component-8448b6f56d-c47g7 Total loading time: 0 Render date: 2024-04-24T23:55:27.667Z Has data issue: false hasContentIssue false
  • English
  • Français

Preparation of (La, Li)TiO3 Dense Ceramics using Sol-Gel and Ion-Exchange Process

Published online by Cambridge University Press:  11 February 2011

Seiichi Suda ,
Hiroyuki Ishii  and
Kiyoshi Kanamura
Seiichi Suda
Affiliation:
Graduate School of Engineering, Tokyo Metropolitan University, 1–1 Minami-Ohsawa, Hachioji, Tokyo 192–0397, Japan.
Hiroyuki Ishii
Affiliation:
Graduate School of Engineering, Tokyo Metropolitan University, 1–1 Minami-Ohsawa, Hachioji, Tokyo 192–0397, Japan.
Kiyoshi Kanamura
Affiliation:
Graduate School of Engineering, Tokyo Metropolitan University, 1–1 Minami-Ohsawa, Hachioji, Tokyo 192–0397, Japan.
Get access

Abstract

Lithium ionic conductor, (La, Li)TiO3, has synthesized with La/Li-TiO2 amorphous spheres that were obtained by sol-gel and ion-exchange method, and succeeding La3+/Li+ partial ion exchange. In this work, La /Li ion exchange conditions were mainly investigated in order to obtain dense (La, Li)TiO3 ceramics that have highly ionic conductivities. La +/Li+ ion exchange behavior was changed with ion-exchange solutions, and the Li/Ti ratio was increased with an increase in ethanol/water ratio in the solvent used for La3+/Li+ partial ion exchange. The use of an adequate ethanol/water ratio resulted in La/Li-TiO2 amorphous spheres with the composition of La/Li/Ti=0.54/0.34/1.00, and sintering of the spheres at 1200°C for 5 h in air led to dense (La, Li)TiO3 ceramics which exhibit the conductivity of 4.0 × 10-3 S cm-1 at 25°C.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 756: Symposia EE/FF – Solid-State Ionics – Materials for Fuel Cells and Fuel Processors , 2002 , EE2.2
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Latie, L., Villeneuve, G, Conte, D. and Flem, G. L., J. Solid State Chem., 51, 293 (1984).Google Scholar
2. Inaguma, Y., Chen, L., Itoh, M. and T. nakamura, Solid State Ionics, 70/71, 196 (1994).Google Scholar
3. Foourquet, J. L., Duroy, H. and Crosnier-Lopez, M. P., J. Solid State Chem., 127, 283 (1996).Google Scholar
4. Inaguma, Y., Itoh, M., Solid State Ionics, 86–88, 257 (1996).Google Scholar
5. Harada, Y, Ishigaki, T., Kawai, H., Kuwano, J., Solid State Ionics, 108, 407 (1998).Google Scholar
6. Katsumata, T., Inaguma, Y., Itoh, M. and Kawanura, K., Chem. Mater., 14, 3930–3936 (2002).Google Scholar
7. Suda, S., Iwaida, M., Yamashita, K. and Umegaki, T., J. Non-Cryst. Soldis, 176, 26 (1994).Google Scholar
8. Suda, S., Iwaida, M., Yamashita, K. and Umegaki, T., J. Non-Cryst. Solids, 197, 65 (1996).Google Scholar
9. Suda, S., Tashiro, T. and Umegaki, T., J. Non-Cryst. Solids, 255, 178 (1999).Google Scholar
10. Matsumoto, M., Suda, S., Yamashita, K. and Umegaki, T., Trans. Mater. Res. Soc. Japan, 25, 257 (2000).Google Scholar
11. Suda, S., Koiwa, T., Kanamura, K. and Umegaki, T., Key Eng. Mater, 206–213, 127 (2002).Google Scholar
12. Ogihara, T., Yanagawa, T., Ogata, N. and Yoshida, K., J. Ceram. Soc. Japan, 101, 315 (1993).Google Scholar
13. Jean, J. H. and Ring, T. A., Am. Ceram. Soc. Bull., 65, 1574 (1986).Google Scholar
14. Jean, J. H. and Ring, T.A., Colloids Surf., 29, 273 (1988).Google Scholar