Hostname: page-component-76fb5796d-qxdb6 Total loading time: 0 Render date: 2024-04-25T10:37:05.160Z Has data issue: false hasContentIssue false
  • English
  • Français

Plasticity of MoSi2 Below 900°C

Published online by Cambridge University Press:  25 February 2011

H. Chang  and
R. Gibala
H. Chang
Affiliation:
Department of Materials Science and EngineeringUniversity of Michigan, Ann Arbor, MI 48109
R. Gibala
Affiliation:
Department of Materials Science and EngineeringUniversity of Michigan, Ann Arbor, MI 48109
Get access

Abstract

The mechanical behavior of polycrystalline MoSi2 tested in compression at temperatures from 750°C to 950°C has been investigated. This material can be deformed to several percent strain without fracture at temperatures as low as 900°C. This same material prestrained at 1300°C and subsequently tested at lower temperatures can be deformed to substantial strain at 800°C, and even exhibits modest plasticity at 750°C. Both prestrained and unprestrained materials exhibit microcracking combined with dislocation substructures containing high densities of dislocations. Unprestrained MoSi2 exhibits a yield point in this temperature range which does not exist when it is prestrained. The stress-strain curves of the prestrained material in this temperature range are similar qualitatively to those of the unprestrained material at 1100°C and above. These observations suggest that at these temperatures MoSi2 is a dislocation density limited material which can deform by dislocation plasticity processes if a sufficient dislocation density is available.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 322: Symposium F – High-Temperature Silicides and Refractory Alloys , 1993 , 223
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Chang, H., Kung, H. and Gibala, R. in Intermetallic Matrix Composites II, edited by Miracle, D. B., Anton, D. L. and Graves, J. A. (Mater. Res. Soc. Proc. 273, Pittsburgh, PA, 1992) pp. 253–258.Google Scholar
2. Evans, D. J., Court, S.A., Hazzledine, P. M. and Fraser, H. L., Phil. Mag. Lett., 67 (5), 331 (1993).CrossRefGoogle Scholar
3. Kim, Y. S., Johnson, M. R., Abbaschian, R. and Kaufman, M. J. in High Temperature Ordered Intermetallic Alloys IV, edited by Johnson, L., Stiegler, J. and Pope, D. (Mater. Res. Soc. Proc. 213, Pittsburgh, PA, 1991) pp. 839–845.Google Scholar
4. Aikin, R. M. Jr., Scripta Metall. et Mater., 26 (7), 1025 (1992).CrossRefGoogle Scholar