Hostname: page-component-848d4c4894-ttngx Total loading time: 0 Render date: 2024-05-12T13:10:29.185Z Has data issue: false hasContentIssue false
  • English
  • Français

Natural Analogue study on the Long-Term Durability of Bentonite –Time-temperature condition and water chemistry on illitization at the Murakami deposit, Japan.–

Published online by Cambridge University Press:  25 February 2011

Kamei G. ,
Yusa Y.  and
Sasaki N.
Kamei G.
Affiliation:
Power Reactor and Nuclear Fuel Development Corporation, Tokai-mura, Ibaraki-ken, 319-11, Japan
Yusa Y.
Affiliation:
Power Reactor and Nuclear Fuel Development Corporation, Tokai-mura, Ibaraki-ken, 319-11, Japan
Sasaki N.
Affiliation:
Power Reactor and Nuclear Fuel Development Corporation, Tokai-mura, Ibaraki-ken, 319-11, Japan
Get access

Abstract

Time-temperature conditions and water chemistry on illitization at the Murakami deposit in central Japan were determined. The extent of the illitization and timetemperature condition estimated were as follows: the duration for conversion from 0 to 80%illite (volumetric ratio) was approximately 3.5Ma in the temperature range from 340 to 100°C. Conversion from 0 to 40% requires approximately 3.0Ma in the temperature range from 240 to 100°C. During 2.0Ma in the temperature range from 160 to 100°C, however, illite was scarcely observed. Water chemistry is estimated from two approaches, namely laboratory experiment and numerical analysis. The former is an interactive experiment between seawater and the tuff of the deposit. The latter is a calculation based on the difference of bulk composition between illitized and non-illitized tuff. The extent of each ionic concentration is inferred to be as follows: K+; 560 to 6400, Mg2+; 800 to 1700, Ca2+; 360 to 2900, Na+; 9400 to 15000 (mg/l).

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 257: Symposium – Scientific Basis for Nuclear Waste Management XV , 1991 , 505
Copyright
Copyright © Materials Research Society 1992

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Kamei, G., Arai, T., Yusa, Y., Sasaki, N., Sakuramoto, Y., Mat. Res. Soc. Symp. Proc., 176, 657–663 (1990).CrossRefGoogle Scholar
[2] Nadeau, P.H., Reynolds, R.C. Jr., Clays and Clay Minerals, 29, 4, 249–259 (1981).CrossRefGoogle Scholar
[3] Brusewitz, A.M., Clays and Clay Minerals, 34, 4, 442–454 (1986).CrossRefGoogle Scholar
[4] Akiba, F., Init. Rep. DSDP, U.S. Govt. Printing Office, Washington, 87, 393–481 (1985).Google Scholar
[5] Watanabe, T., Clay Science, 7, 97–114 (1988).Google Scholar
[6] Wagner, G.A., Reimer, G.M., Jager, E., Mem. 1st Geol. Mineral. Univ. Padova, 30 (1977).Google Scholar
[7] Harrison, T.M., Armstrong, R.L., Naeser, C.W., Harakal, J.E., Jour. Earth. Sci., 16, 400 (1979).Google Scholar
[8] Hurford, A.J., Contrib. Mineral. Petrol., 92, 413 (1986).CrossRefGoogle Scholar
[9] Iwata, K., PNC N9520 89-019 FINAS:RMO02, VERSION 11.0 (1989),(in Japanese).Google Scholar
[10] Aoyagi, K., Kazama, T., Sedimentology 27, 179–188 (1980).CrossRefGoogle Scholar
[11] Roberson, H.E., Lahann, R.W., Clays and Clay Minerals 29, 2, 129–135 (1981).CrossRefGoogle Scholar
[12] Howard, J.J., Roy, D.M., Clays and Clay Minerals 33, 2, 81–88 (1985).CrossRefGoogle Scholar