Hostname: page-component-cd9895bd7-jkksz Total loading time: 0 Render date: 2024-12-21T13:28:23.390Z Has data issue: false hasContentIssue false
  • English
  • Français

Microstructural Design of Si3N4 Based Ceramics

Published online by Cambridge University Press:  25 February 2011

M.J. Hoffmann  and
G. Petzow
M.J. Hoffmann
Affiliation:
Max-Planck-Institut für Metallforschung, Institut für Werkstoffwissenschaft, Pulvermetallurgisches Laboratorium, Heisenbergstr. 5, D-7000 Stuttgart 80, Germany
G. Petzow
Affiliation:
Max-Planck-Institut für Metallforschung, Institut für Werkstoffwissenschaft, Pulvermetallurgisches Laboratorium, Heisenbergstr. 5, D-7000 Stuttgart 80, Germany
Get access

Abstract

Parameters controlling the size and aspect ratio of elongated Si3N4 grains are discussed, based on the assumption that only pre-existing β-Si3N4 particles of the starting powder grow. Powder mixtures of α-rich and β-rich Si3N4 were prepared In order to study the microstructural development. The resulting microstructures were analyzed by quantitative microstructural analysis determining the distribution of the length and aspect ratio of the Si3N4 grains. Subsequently, the Influence of the sintering conditions on grain growth was analyzed In relation to mechanical properties. A high Weibull modulus and the non-catastrophic failure during thermal shock of coarse-grained materials Is attributed to an R-curve behaviour. Finally, the influence of sintering additives on the mechanical properties was studied. The Importance of phase relationships between the matrix and the grain boundary phase Is discussed for Si3N4 with Yb2O3 additives. It Is demonstrated that the oxygen content of Si3N4 powder must been taken Into account In order to devitrify defined secondary phases and to achieve a high degree of crystallization. A reduction in the amount of additives does not necessarily Improve the properties as high temperature strength and creep data Indicate.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 287: Symposium K – Silicon Nitride Ceramics–Scientific and Technological Advances , 1992 , 3
Copyright
Copyright © Materials Research Society 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Terwillinger, G.R. and Lange, F.F., J.Mater.Sci., 10, (1975), 1169.Google Scholar
[2] Boskovic, S., Gaukler, L.J., Petzow, G. and Tien, T.Y., Pow.Met., 9, (1977), 185.Google Scholar
[3] Hitomo, M., J. Mat. Sci., 11, (1976), 1103.Google Scholar
[4] Peukert, M. and Greil, P., J. Mat. Sci., 22, (1987), 213.Google Scholar
[5] Weiss, J. and Kaysser, W.A., in Riley, F.L. (ed.), Progress in Nitrogen Ceramics, (1983), 169.Google Scholar
[6] Bressani, J., Ph.D. Thesis, University Stuttgart, (1984).Google Scholar
[7] Butler, E., Lumby, R.J., Szweda, A. and Lewis, M., in: Somiya, S. et al. (eds.), Proc. Int. Symp. on Ceramic Component for Eng., Tokyo, (1983).Google Scholar
[8] Lange, F.F., J. Am. Ceram. Soc., 62, (1979), 428.Google Scholar
[9] Mitomo, M., Tsutsuml, M., Tanaka, H., Uenosono, S., Salto, F., “Grain Growth During Gas-Pressure Sintering of β-Silicon Nitride”, J. Am. Ceram. Soc., 73, [8], (1990), 2441–2445.Google Scholar
[10] Dressler, W., Hoffmann, M.J., and Petzow, G., “Analysis of Microstructural Development in Si3N4-Ceramics”, Presentation at the 44th Pacific Coast Regional Meeting of ACS, San Diego (CA/USA), November 1991.Google Scholar
[11] Petzow, G. und Hoffmann, M.J., “Grain Growth Studies in Si3N4-Ceramics”, Materials Science Forum Vols. 113–115, Trans. Tech. Publications, Switzerland, (1993), 91–102.Google Scholar
[12] Dressler, W., “Microstructural Development and Mechanical Properties of Si3N4 Ceramics”, Ph.D. Thesis, University Stuttgart, (1993).Google Scholar
[13] Mitomo, M., Uenosono, S., “Microstructural Development During Gas-Pressure Sintering of β-Silicon Nitride”, J. Am. Ceram. Soc., 75, [1], (1992), 103–108.Google Scholar
[14] Becher, P.F., Lin, H.T., Hwang, S.L., Hoffmann, M.J., and Chen, I.W., “The Influence of Microstructure on the Mechanical Behaviour of Silicon Nitride Ceramics”, MRS-Proceedings, this volume, (1993).Google Scholar
[15] Schneider, G.A., DebschUtz, K.D., and Petzow, G. “Strength Variability of Ceramics with Rising Crack Growth Resistance”, submitted to Acta Met. (1992).Google Scholar
[16] Hoffmann, M.J., Schneider, G.A., and Petzow, G., “The Potential of Si3N4 for Thermal Shock Applications”, to be published In Thermal Schock and Thermal Fatigue Behaviour of Advanced Ceramics, Schneider, G.A. and Petzow, G. (eds.), NATO ASI Series, (1993).Google Scholar
[17] Tajima, Y., Urashima, K., Watanabe, M., and Matsuo, Y., “Fracture Toughness and Microstructure Evaluation of Silicon Nitride Ceramics”, In Ceramics Transactions, Vol.1: Ceramic Powder Science-IIB, Messing, G.L., Fuller, E.R. Jr., and Hausner, H. (editors), Am. Ceram. Soc., Westerville, OH, (1988), 1034–41.Google Scholar
[18] Gaukler, L.J. and Petzow, G., “Representation of Multicomponent Silicon Nitride Based Ceramics”, In Nitrogen Ceramics, Riley, F.R. (ed.), NATO Advanced Study Institute, Canterbury, UK, (1976).Google Scholar
[19] Hoffmann, M.J., J. Gr6bner, Hampp, E., and Petzow, G., to be published.Google Scholar
[20] Patel, J.K. and Thompson, D.P., “The Low-temperature Oxidation Problem In Yttria-densified Silicon Nitride Ceramics”, Brit. Ceram. Trans. J., 87, (1988), 70.Google Scholar
[21] Hampp, E., “Phase Relationships and Sintering Behaviour of Yb-Doped Si3N4”, Ph.D. Thesis, University Stuttgart, 1993.Google Scholar
[22] Gaukler, L.J., Hohnke, H. and Tien, T.Y., “The System Si3N4-SiO2-Y203 ”, J. Am. Ceram. Soc., 63, (1973), 35.Google Scholar
[23] Kleebe, H.J., Hoffmann, M.J. and Rühle, M., “Influence of Secondary Phase Chemistry on Grain-Boundary Film Thickness in Silicon Nitride”, Z. Metallkde, 83, [8], (1992), 610–17.Google Scholar