Hostname: page-component-77c89778f8-rkxrd Total loading time: 0 Render date: 2024-07-16T11:11:16.538Z Has data issue: false hasContentIssue false
  • English
  • Français

Large Area Surface Treatment by Ion Beam Technology

Published online by Cambridge University Press:  03 September 2012

R. L. C. Wu  and
W. Lanter
R. L. C. Wu
Affiliation:
K Systems Corporation, 1522 Marsetta Drive, Beavercreek, Ohio 45432
W. Lanter
Affiliation:
K Systems Corporation, 1522 Marsetta Drive, Beavercreek, Ohio 45432
Get access

Abstract

An ultra high vacuum ion beam system, consisting of a 20 cm diameter Rf excilted (13.56 MHz) ion gun and a four-axis substrate scanner, has been used to modify large surfaces (up to 1000 cm2) of various materials, including; infrared windows, silicon nitride, polycrystalline diamond, 304 and 316 stainless steels, 440C and M50 steels, aluminum alloys, and polycarbonates; by depositing different chemical compositions of diamond-like carbon films. The influences of ion energy, Rf power, gas composition (H2/CH4 , Ar/CH4 and O2/CH4/H2), on the diamond-like carbon characteristics has been studied. Particular attention was focused on adhesion, environmental effects, IR(3–12 μm) transmission, coefficient of friction, and wear factors under spacelike environments of diamond-like carbon films on various substrates. A quadrupole mass spectrometer was utilized to monitor the ion beam composition for quality control and process optimization.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 438: Symposium A – Materials Modificaton and Synthesis by Ion Beam… , 1996 , 611
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] Wu, R.L.C., Lanter, W., Miyoshi, K., Heidger, S.L., Bletzinger, P. and Garscadden, A., in Beam-Solid Interactions for Materials Synthesis and Characterization, edited by Jacobson, D. C., Luzzi, D.E., Heinz, T. F. and Iwaki, M. (Mater. Res. Soc. Proc. Vol.354, Pittsburgh, PA 1995) p. 63–68..Google Scholar
[2] Augus, J.C., Koidl, P., Domitz, S., In Plasma Deposited Thin Film, edited by Mort, J. and Jansen, F., (CRC Press, Boca Raton, Fl., 1986), Chapter 4.Google Scholar
[3] Miyoshi, K., Wu, R.L.C. and Lanter, W., NASA Technical Memorandum 107316 (1996).Google Scholar
[4] Humidity Test in MIL 507.Google Scholar
[5] Salt Fog Test in MIL 13508.Google Scholar
[6] Wu, R.L.C., Surf. and Coat. Tech. 51, 258 (1992).Google Scholar
[7] Vuppuladhadium, R., Jackson, H.E. and Wu, R.L.C., J. Appl. Phys. 77, 2714 (1995).Google Scholar
[8] Tsai, H., Materials Science Form Vols. 52 & 53, edited by Pouch, J.J. and Alterovitz, S.A., (Trans Tech Publications 1995), p 71–102.Google Scholar