Hostname: page-component-848d4c4894-ndmmz Total loading time: 0 Render date: 2024-05-13T15:36:26.231Z Has data issue: false hasContentIssue false

Effects of Irradiation by Low Energy Nitrogen Ions on Carbon Nitride Thin Films

Published online by Cambridge University Press:  11 February 2011

Yuka Nasu
Affiliation:
Department of Materials Science and Engineering, National Defense Academy, 1–10–20 Hashirimizu, Yokosuka, Kanagawa 239–8686, Japan
Masami Aono
Affiliation:
Department of Materials Science and Engineering, National Defense Academy, 1–10–20 Hashirimizu, Yokosuka, Kanagawa 239–8686, Japan
Shinichiro Aizawa
Affiliation:
Department of Materials Science and Engineering, National Defense Academy, 1–10–20 Hashirimizu, Yokosuka, Kanagawa 239–8686, Japan
Nobuaki Kitazawa
Affiliation:
Department of Materials Science and Engineering, National Defense Academy, 1–10–20 Hashirimizu, Yokosuka, Kanagawa 239–8686, Japan
Yoshihisa Watanabe
Affiliation:
Department of Materials Science and Engineering, National Defense Academy, 1–10–20 Hashirimizu, Yokosuka, Kanagawa 239–8686, Japan
Get access

Abstract

Carbon nitride (CNx) thin films have been prepared by hot carbon filament chemical vapor deposition, and the nitrogen content in the films is approximately 0.05. The CNx films have been irradiated by 0.1 keV nitrogen ions to increase the nitrogen content after deposition. The nitrogen content in the CNx films was obtained with X-ray photoelectron spectroscopy. Scanning electron microscopy was employed to study microstructures of the films. The experimental results show that nitrogen ions are chemically combined with the CNx films and as a result the nitrogen content increases up to approximately 0.30. Furthermore, it is found that nitrogen ions change the film microstructures and sputter the surfaces of CNx films.

Type
Research Article
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Liu, A. Y. and Cohen, M. L., Science 245, 841 (1989).Google Scholar
2. Ren, Z. F., Huang, Z. P., Xu, J. W., Wang, J. H., Bush, P., Siegal, M. P. and Provencio, P. N., Science 282, 1105 (1998).Google Scholar
3. Marton, D., Boyd, K. J., Al-Bayati, A. H., Todorov, S. S. and Rabalais, J. W., Phys. Rev. Lett. 73, 118 (1994).Google Scholar
4. Aono, M., Nitta, S., Iwasaki, T., Yokoi, H., Itoh, T. and Nonomura, S. in Low-Dielectric Constant Materials V, edited by Hummel, J., Endo, K., Lee, W. W., Mills, M., Wang, S.-Q., (Mater. Res. Soc. Proc. 565, Pennsylvania, 1999) p. 291.Google Scholar
5. Veprek, S., Weidmann, J. and Glatz, F., J. Vac. Sci. Technol. A13, 2914 (1995).Google Scholar
6. Palacio, C., Gomez-Aleixandre, C., Diaz, D. and Garcia, M.M., Vaccum 48, 709 (1997).Google Scholar
7. Gouzman, I., Brener, R., Hoffman, A., Thin solid films 253, 90 (1994).Google Scholar
8. Yamamoto, K., Koga, Y., Yase, K., Fujiwara, S. and Kubota, M., Jpn. J. Appl. Phys. 36, 230 (1997).Google Scholar
9. Kitazawa, N., Kasai, H., Watanabe, Y. and Nakamura, Y., Surf. Coat. Technol, 120–121, 418 (1999)Google Scholar
10. Boyd, K. J., Marton, D., Todorov, S. S., Al-Bayati, A. H., Kulik, J., Zuhr, R.A. and Rabalais, J.W., J. Vac. Sci. Tachnol. A13, 2110 (1995).Google Scholar
11. Bhattacharya, S., Cardinaud, C. and Turbun, G., J. Appl. Phys. 83, 4491(1998).Google Scholar