Hostname: page-component-8448b6f56d-c4f8m Total loading time: 0 Render date: 2024-04-19T13:52:33.278Z Has data issue: false hasContentIssue false

Effects of ion-beam irradiation on the L10 phase transformation and their magnetic properties of FePt and PtMn films (Invited)

Published online by Cambridge University Press:  26 February 2011

Chih-Haung Lai
Affiliation:
chlai@mx.nthu.edu.tw, National Tsing Hua University, Department of Materials Science and Engineering, 101, Section 2 Kuang Fu Road, Hsinchu, 30013, Taiwan, 886-3-5715131-3822, 886-3-5710070
Sheng-Huang Huang
Affiliation:
adf@doya.url.com.tw, National Tsing Hua University, Department of Materials Science and Engineering, Taiwan
Cheng-Han Yang
Affiliation:
g903521@alumni.nthu.edu.tw, National Tsing Hua University, Department of Materials Science and Engineering, Taiwan
C.C. Chiang
Affiliation:
d937531@oz.nthu.edu.tw, National Tsing Hua University, Department of Materials Science and Engineering
S. H. Liou
Affiliation:
sliou1@unl.edu, University of Nebraska, Department of Physics and Astronomy
D. J. Sellmyer
Affiliation:
dsellmyer@unl.edu, University of Nebraska, Department of Physics and Astronomy
M. L. Yan
Affiliation:
myan@unlserve.unl.edu, University of Nebraska, Department of Physics and Astronomy
L. Yuan
Affiliation:
sliou1@unl.edu, University of Nebraska, Department of Physics and Astronomy
T. Yokata
Affiliation:
sliou@unl.edu, Nagoya institute of Technology, Department of Environmental Engineering of Materials, Japan
Get access

Abstract

Ion-beam irradiation shows enhancement or degradation of magnetic properties on L10 phase of FePt and PtMn films. A highly ordered L10 FePt phase was directly achieved by using 2 MeV He-ion irradiation without conventional postannealing. The in-plane coercivity greater than 5700 Oe can be obtained after disordered FePt films were irradiated at the beam current of several μA/cm2 with the ion does of 2.4×1016 ions/cm2. The high beam-current-density results in direct beam heating on samples. In addition, the irradiation-induced heating process provides efficient microscopic energy transfer and creates excess point defects, which significantly enhances the diffusion and promotes the formation of the ordered phase. Consequently, the direct ordering of FePt took place by using ion-irradiation heating at temperature as low as 230°C. The comparison has been made on the [Fe/Pt]10/C films by RTA and high current-density He irradiation. Although RTA and ion irradiation both reach high coercivity, ion irradiation seems to suppress the (001) texture, leading to isotropic Hc. Ion-beam irradiation can also be applied to the transformation of PtMn. An ordered PtMn phase, a large exchange field and a high GMR ratio (11%) were obtained in PtMn-based spin valves by using 1.25 μA/cm2 He-ions. On the other hand, Ge-ion and O-ion irradiation completely destroyed the ferromagnetism of FePt and GMR of PtMn-based spin valves, respectively. We propose a novel approach to achieve magnetic patterning by using ion irradiation, which can be applied for patterned media and magnetic sensors.

Type
Research Article
Copyright
Copyright © Materials Research Society 2006

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCE

1. Malozemoff, A. P., Phys. Rev. B 35, 3679 (1987).Google Scholar
2. Mauri, D., Siegmann, H. C., Bagus, P. S., and Kay, E., J. Appl. Phys. 62, 3047 (1987).Google Scholar
3. Coffey, K., Parker, M. A., and Howard, J. K., IEEE Trans. Magn. 31, 2737 (1995).Google Scholar
4. Chang, G. S., Callcott, T. A., Zhang, G. P., Woods, G. T., Kim, S. H., Shin, S. W., Jeong, K., Whang, C. N., and Moewes, A., Appl. Phys. Lett. 81, 3016 (2002).Google Scholar
5. Kelly, D. M., Schuller, I. K., Korenivski, V., Rao, K. V., Larsen, K. K., Bottiger, J., Gyorgy, E. M., and van Dover, R. B., Phys. Rev. B 50, 3481 (1994).Google Scholar
6. Chang, G. S., Lee, Y. P., Rhee, J.Y., Lee, J., Jeong, K., and Whang, C. N., Phys. Rev. Lett. 87, 067208 (2001).Google Scholar
7. Ravelosona, D., Chappert, C., Mathet, V., and Bernas, H., Appl. Phys. Lett. 76, 236 (2000).Google Scholar
8. Folks, L., Baglin, J. E. E., Kellock, A. J., Carey, M. J., Terris, B. D., and Gurney, B., IEEE Trans. Magn. 37, 1730 (2001).Google Scholar
9. Mougin, A., Mewes, T., Jung, M., Engel, D., Ehresmann, A., Schmoranzer, H., Fassbender, J., and Hillebrands, B., Phys. Rev. B 63, 060409(R) (2001).Google Scholar
10. Lai, C. H., Yang, C.H., Huang, R. T., Chen, C. W., Chen, F. R., Kai, J. J., Niu, H., J. Magn. Magn. Mater. 239, 390 (2002)Google Scholar
11. Yang, C. H., Lai, C. H., Mao, S., J. Appl. Phys. 93, 6596 (2003)Google Scholar
12. Ziegler, J. F., and Biersak, J. P., http://www.srim.org/.Google Scholar
13. Warren, B. E., X-Ray Diffraction (Addison-Wesley, Reading, MA, 1969) pp.208.Google Scholar
14. Seitz, F. and Keohler, J. S., Solid State Phys. 2, 305 (1956).Google Scholar
15. Zhu, D. H., Lu, H. B., Tao, K., and Liu, B. X., J. Phys.: Condens. Matter 5, 5505 (1993).Google Scholar
16. Terris, B. D, Folks, L., Weller, D., Appl. Phys. Lett. 75, 403 (1999)Google Scholar