Hostname: page-component-8448b6f56d-qsmjn Total loading time: 0 Render date: 2024-04-24T07:44:45.740Z Has data issue: false hasContentIssue false

Control of the Electron and Hole Drift mobilities in Plasma Deposited a-Si:H

Published online by Cambridge University Press:  16 February 2011

Gautam Ganguly
Affiliation:
Electrotechnical Laboratory, 1–1–4 UMezono, Tsukuba City, Ibaraki, Japan
Akihisa Matsuda
Affiliation:
Electrotechnical Laboratory, 1–1–4 UMezono, Tsukuba City, Ibaraki, Japan
Get access

Abstract

The ‘time-of-flight’ technique measured electron and hole drift mobilities are shown to be independent of deposition parameters in capacitively coupled, diode type RF-PECVD a-Si:H. However, the carrier mobilities can be varied by orders of magnitude by changing the bias applied to the mesh type controlling electrode in a triode type reactor. The room temperature hole drift mobility increases to 10−1cm2/Vs when an appropriate bias is applied to the mesh providing optimum energy ion stimulation of the film growth surface during deposition. Analysis of the field and temperature dependences of the drift mobilities shows that in the best specimens the conduction (valence) band tail density of states are approximately exponential with a reciprocal slope of lOMeV (25MeV).

Type
Research Article
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Ganguly, I.G. and Matsuda, A., Phys. Rev. B 47, 3661 (1993).Google Scholar
2 Ganguly, G. and Matsuda, A., in Amorphous Silicon Technology - 1992, edited by Thompson, M.J., Hamakawa, Y., LeComber, P.G., Madan, A. and Schiff, E.A. (Mater. Res. Soc. Proc. 258, Pittsburg, PA, 1992) p-39.Google Scholar
3 Nishio, H., Ganguly, G. and Matsuda, A., Amorphous Silicon Technology - 1993, edited by Schiff, E.A., Thompson, M.J., Madan, A., Tanaka, K. and LeComber, P.G., (Mater. Res. Soc. Proc. 297, Pittsburg, PA, 1993) p-91.Google Scholar
4 Tiedge, T., Cebulka, J.M., Morel, D. and Abeles, B., Phys. Rev. Lett. 46, 1425 (1981).Google Scholar
5 Scher, H. and Montroll, E.W., Phys. Rev. B 12, 2455 (1975).Google Scholar
6 Marshall, J.M., Rep. Prog. Phys. 46, 1235 (1983).CrossRefGoogle Scholar
7 LeComber, P.G. and Spear, W.E., Phys. Rev. Lett. 25, 509 (1970).Google Scholar
8 Moore, A.R., Appl. Phys. Lett. 31, 762 (1977).Google Scholar
9 Marshall, J.M., Street, R.A. and Thompson, M.J., J. Non-Cryst. Solids 66, 175 (1984).Google Scholar
10 Spear, W.E. and Steemers, H.L., J. Non-Cryst. Solids 66, 163 (1984).Google Scholar
11 Murayama, K., Oheda, H., Yamasaki, S. and Matsuda, A., Solid State Commun. 81, 887 (1992).Google Scholar
12 Antoniadis, and Schiff, E.A., Phys. Rev. B 43, 13957 (1991).Google Scholar
13 Das, D., Shirai, H., Hanna, J. and Shimizu, I., Jpn. J. Appl. Phys. 30, L239 (1991).CrossRefGoogle Scholar
14 Street, R.A., Zesch, J. and Thompson, M.J., Appl. Phys. Lett. 43, 672 (1983).Google Scholar
15 Marshall, J.M., Street, R.A. and Thompson, M.J., Phys. Rev. B 29, 2331 (1984).Google Scholar
16 Spear, W.E., J. Non-Cryst. Solids 1, 197 (1968).Google Scholar
17 Kocka, J., Klima, O., Šipek, E., Nebel, C.E., Bauer, G.H., Juska, G. and Hoheisel, M., Phys. Rev. B 45, 6593 (1992).Google Scholar
18 Matsuda, A., Nakagawa, K., Tanaka, K., Matsumura, M., Yamasaki, S., Okushi, H. and Iizima, S., J. Non-Cryst. Solids 35/36, 183 (1985).Google Scholar
19 Matsuda, A. and Tanaka, K., Thin Solid Films 60, 147 (1979).Google Scholar
20 Kamimura, , Nozaki, H., Sakuma, N. and Ito, H., Jpn. J. Appl. Phys. 27, L1803 (1988).Google Scholar
21 Marshall, J.M., Street, R.A. and Thompson, M.J., Phil. Mag. B 54, 51 (1986).Google Scholar
22 Marshall, J.M., Street, R.A., Thompson, M.J. and Jackson, W.B., Phil mag. B57, 387 (1985).Google Scholar
23 Nebel, C.E. and Bauer, G.H., Phil. Mag. B 59, 463 (1989).CrossRefGoogle Scholar
24 Nebel, C.E., Street, R.A., Johnson, N.M. and Walker, J., in ref. 3, p-297 (1993).CrossRefGoogle Scholar
25 Wang, Q., Antoniadis, H, Schiff, E.A. and Guha, S., in ref. 2, p-881 (1992).Google Scholar