Hostname: page-component-7c8c6479df-fqc5m Total loading time: 0 Render date: 2024-03-28T17:56:55.568Z Has data issue: false hasContentIssue false

Composition, Size, Structure, and Magnetic Characterization of Iron-Platinum Nano-particles

Published online by Cambridge University Press:  15 March 2011

N. Parekh
Affiliation:
Department of Chemical and Materials Engineering, San Jose State University
G. Young
Affiliation:
Department of Chemical and Materials Engineering, San Jose State University
A. Singh
Affiliation:
Department of Chemical and Materials Engineering, San Jose State University
K. Parvin
Affiliation:
Department of Physics and Astronomy, San Jose State University
M. Kaur
Affiliation:
Department of Physics and Astronomy, San Jose State University
D. Bruck
Affiliation:
Department of Biological Sciences, San Jose State University
S. Wong
Affiliation:
Department of Biological Sciences, San Jose State University
Get access

Abstract

Iron-platinum (FePt) nano-particles were synthesized using a hot metal salt reduction reaction with iron chloride and platinum acetylacetonate as the precursor salts. The synthesis route was based upon work done previously by Sun et Al.[6]. The size and composition of the FePt nano-particles were controlled by varying the surfactant to reagent molar ratio and refluxing time during synthesis. The average size of FePt nano-particles synthesized ranged from 4.08 nm to 5.23 nm. The composition of the nano-particles ranged from Fe60Pt40 to Fe55Pt45. The size was shown to increase as the surfactant to reagent molar ratio was changed from 1:6 to 1:1. The platinum composition increased from 40 % to 45 % with an increase in the refluxing time from 30 minutes to 60 minutes. The X-ray analysis (XRD) showed that the unannealed nano-particles had a FCC crystal structure. The FCC FePt nano-particles were superparamagnetic at room temperature. A blocking temperature (Tb) of 35 K was measured for 5.23 nm Fe55Pt45 nano-particles. Annealing of the Fe55Pt45 nano-particles induced a FCT crystal structure with hard-magnetic properties. Coercivity (Hc) of approximately 13000 Oe was measured at room temperature.

(a) Department of Chemical and Materials Engineering, San Jose State University

(b) Department of Physics and Astronomy, San Jose State University

(c) Department of Biological Sciences, San Jose State University

Type
Research Article
Copyright
Copyright © Materials Research Society 2009

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Asheghi, M. and Yang, Y. “Micro-and Nano-scale Diagnostic Techniques for Thermometry and Thermal Imaging of Microelectronic and Data Storage Devices” Microscale Diagnostic Techniques ed. Breuer, K. (Springer, 2005) pp 160.Google Scholar
2. Li, N., Lairson, B. M., IEEE Trans. Magn. 35, pp 1077 (1999).Google Scholar
3. Chen, M., Liu, J.P., Sun, S., J. AM. CHEM. SOC. 126, pp 8394 (2004).Google Scholar
4. Momose, S., Kodama, H, Uzumaki, T., Tanaka, A, Jpn. J. Appl. Phys., Part 1, 44, p 1147, (2005)Google Scholar
5. Sun, S., Anders, S., Murray, C. B., Weller, D, Folks, L, Science, 287, pp 1989 (2000).Google Scholar
6. Sun, S., Anders, S., Thomson, T., Baglin, J. E. E., Toney, M. F., Hamann, H.F., Murray, C. B., Tervis, B. D., J. Phys. Chem. B, 107, p 5419 (2003).Google Scholar
7. Singh, A., Young, G., Kaur, M., Parvin, K., Wong, S., Bruck, D., Varasteh, M. 2007 MRS Spring Meeting MRS Proceedings Volume 998EGoogle Scholar
8. Cao, GuozhongNanostructures and Nanomaterials” (World Scientific Publishing Company, Incorporated, 2004) pp 5162 Google Scholar
9. Talapin, D. V., Shevchenko, E. V., Weller, H. “Synthesis and Characterization of Magnetic Nano-particles” Nano-particles, ed. Schmid, G., (Willey-VCH, 2003) pp. 229.Google Scholar