Hostname: page-component-8448b6f56d-mp689 Total loading time: 0 Render date: 2024-04-19T06:24:23.547Z Has data issue: false hasContentIssue false
  • English
  • Français

Chemically Assisted ion-Beam Etching of Sol-Gel Derived Pzt, Plzt And LITaO3 Thin Films for Silicon Based Device Integration

Published online by Cambridge University Press:  21 February 2011

P. F. Baude ,
C. Ye  and
D.L. Polla
P. F. Baude
Affiliation:
University of Minnesota, Microelectromechanical Systems Center Department of Electrical Engineering Minneapolis, MN 55455
C. Ye
Affiliation:
University of Minnesota, Microelectromechanical Systems Center Department of Electrical Engineering Minneapolis, MN 55455
D.L. Polla
Affiliation:
University of Minnesota, Microelectromechanical Systems Center Department of Electrical Engineering Minneapolis, MN 55455
Get access

Abstract

Wet chemical, reactive ion etching and reactive ion-beam etching of sol-gel prepared PZT (54/46) [Pb(Zr,Ti)O3], Lanthanum doped PZT [PLZT (9/65/35)] and LiTaO3 have been investigated. Wet chemical etching using an HCI-HF solution, reactive-ion etching using a SF6 plasma and chemically assisted ion-beam etching (CAIBE) using a xenon plasma and chlorine reactive gas were used. Etch rates for each method were determined and the ability to define small features in the thin film ferroelectric was investigated. It was found that for structures smaller than approximately 20 × 20 μm2, chemically assisted ion beam etching provided by far the best results. 3 × 3 μm2 capacitor and 2 μm wide optical waveguide structures in PZT, PLZT respectively, were successfully fabricated using a CAIBE system. An etch depth monitor enabled accurate in-situ etch rate monitoring of the PLZT and PZT thin films.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 310: Symposium N – Ferroelectric Thin Films III , 1993 , 139
Copyright
Copyright © Materials Research Society 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Ye, C., Tamagawa, T., and Polla, D.L., J. Appl. Phys, 70, 5538, 1991 CrossRefGoogle Scholar
2. Swartz, S.L., Bright, S.J., Melling, P.J., and Shrout, T.R., Ferroelectrics, 108, 71, (1990)Google Scholar
3. Choi, J., PhD Thesis, GaAs Microsensors, University of Minnesota, Dept. of EE, 1990 Google Scholar
4. Baude, P.F., Ye, C., Tamagawa, T., and Polla, D.L., J. Appl. Phys., 73, 7960 (1993)Google Scholar
5. Baude, P.F., MSEE Thesis, University of Minnesota, Dept. of EE, June 1993 Google Scholar
6. Poor, M.R. and Fleddermann, C.B., J. Appl. Phys. 70, 3385 (1991)Google Scholar
7. Pan, W., Vijay, D. P. and Desu, S.B., Presented at the 1993 Spring MRS Meeting, San Francisco, CA Google Scholar
8. Baude, P., Ye, C., Tamagawa, T., and Polla, D.L., Proceedings of the Fall 1992 MRS Meeting, 1992, Boston MA, (1993)Google Scholar